Abstract:AgSbSe2 is a typical member of cubic I–V–VI2 semiconductors, which are known for their extremely low lattice thermal conductivity (κl). However, the low electrical conductivity of AgSbSe2, below ∼10 S cm–1 at room temperature, has hindered its thermoelectric performance. In this work, single-phase AgSbSe2 bulk samples with much higher electrical conductivity were synthesized via self-propagating high-temperature synthesis (SHS) combined with spark plasma sintering (SPS) for the first time. Pb doping through the nonequilibrium process further increases the electrical conductivity to >100 S cm–1. Furthermore, continuously increased effective mass md* can be achieved upon Pb doping because of the multiple degenerate valence bands of AgSbSe2 and the energy-filtering effect induced by in situ-formed nanodots. The simultaneous enhancement of both the electrical conductivity and Seebeck coefficient contributes to an unprecedentedly high average power factor of 6.75 μW cm–1 K–2. Meanwhile, the introduced dense grain boundaries and point defects enhance the phonon scattering and consequently suppress κl, yielding a high ZT value of 1.2 at 723 K in AgSb0.94Pb0.06Se2. This study opens a new avenue for rapid, low-cost, large-scale production of AgSbSe2-based materials and demonstrates that Pb-doped AgSbSe2 prepared via the SHS–SPS method is a promising candidate for thermoelectric applications.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c10508?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c10508</a>.Part of the thermoelectric properties of AgSb1–xPbxSe2, temperature-dependent electronic thermal conductivity, Lorentz constant, diffusivity, heat capacity, and the elemental quantitative analysis by EPMA for AgSb1–xPbxSe2 (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c10508/suppl_file/am0c10508_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

High Pressure Synthesis and Electrical Properties of Ag1-x Pb18 SbTe20

Microstructure and Thermoelectric Properties of Cubic AgPb18Sb1−xTe20 (x = 0.1, 0.3, 0.5) Compounds

Fabrication and Property of High-Performance Ag-Pb-Sb-Te System Semiconducting Thermoelectric Materials

Nanostructure and High Thermoelectric Performance in Nonstoichiometric AgPbSbTe Compounds: the Role of Ag

Effect of PbTe on Thermoelectric Properties of Co 0.88 Ni 0.12 Sb 2.91 Sn 0.09

High-performance Ag0.8Pb18+xSbTe20 Thermoelectric Bulk Materials Fabricated by Mechanical Alloying and Spark Plasma Sintering

High Thermoelectric Performance of AgSb 1– x Pb x Se 2 Prepared by Fast Nonequilibrium Synthesis

Thermoelectric Performance of AgPb X SbTe 20 ( X = 17 to 23) Bulk Materials Derived from Large-Particle Raw Materials

Effect of Pbte on Thermoelectric Properties of Co0.88ni0.12sb2.91sn0.09

Realizing High Thermoelectric Performance in Sb-Doped Ag 2 Te Compounds with a Low-Temperature Monoclinic Structure

High Thermoelectric Performance of AgSb1-xPbxSe2 Prepared by Fast Non-Equilibrium Synthesis.

High-Pressure Synthesis of Te-Ge Double-Substituted Skutterudite with Enhanced Thermoelectric Properties

Fast Preparation of AgxPb20SbTe20 (x = 0.5–3) Component with High Thermoelectric Performance

Thermoelectric Properties of the Cubic AgPb10SbTe12

Thermoelectric properties of nonstoichiometric PbTe prepared by HPHT

Chemical Pressure-Driven Band Convergence and Discordant Atoms Intensify Phonon Scattering Leading to High Thermoelectric Performance in SnTe

Superconductivity in In-doped AgPbBiTe3 compounds synthesized by high-pressure synthesis

Thermoelectric Properties of Xpbte/yb0.2co4sb12 Hot-Pressed Samples

Band convergence and nanostructure modulations lead to high thermoelectric performance in SnPb0.04Te-y% AgSbTe2

Reduced thermal conductivity in Pb-alloyed AgSbTe_2thermoelectric materials

Melt-slow Cooling Synthesis and Thermoelectric Properties of Pb9.6SbmTe3Se7 Alloys