Abstract:Nitrous oxide (N 2 O) is the third most important greenhouse gas modified by human activities after carbon dioxide and methane. This study examines the feasibility of airborne differential absorption lidar to measure N 2 O concentration enhancements over agricultural, fossil fuel combustion, industrial, and biomass burning sources. The mid-infrared spectral region, where suitably strong N 2 O absorption lines exist, challenges passive remote sensing by means of spectroscopy due to both low solar radiation and thermal emission. Lidar remote sensing is principally possible thanks to the laser as an independent radiation source but has not yet been realized due to technological challenges. Mid-infrared N 2 O absorption bands suitable for remote sensing are investigated. Simulations show that a spectral trough position between two strong N 2 O lines in the 4.5 μm band is the favored option. A second option exists in the 3.9 μm band at the cost of higher laser frequency stability constraints and less measurement sensitivity. Both options fulfill the N 2 O measurement requirements for agricultural areal or point-source emission quantification (0.5 % measurement precision, 500 m spatial resolution) with technically realizable and affordable transmitter (100 mW average laser power) and receiver (20 cm telescope) characteristics for integrated-path differential absorption lidar that measures the column concentration beneath the aircraft. The development of an airborne N 2 O lidar is feasible yet would benefit from progress in infrared laser transmitter and low-noise-detection technology. It will also serve as a precursor to space versions, which are still out of reach due to the lack of space technology.

Design and implementation of NO2 differential absorption lidar sources

High Repetition Rate Mid-Infrared Differential Absorption Lidar for Atmospheric Pollution Detection

Design of an Optical Fiber-Grating Spectrum-Dividing System for NO 2 -DIAL

Development of the Zju Polarized Near-Infrared High Spectral Resolution Lidar

Multi-Longitudinal-Mode High-Spectral-Resolution Lidar

Design study for an airborne N2O lidar

Development of a 443 nm diode laser-based differential photoacoustic spectrometer for simultaneous measurements of aerosol absorption and NO2

Simultaneous Measurement of SO 2 and NO 2 Concentration Using an Optical Fiber-Based LP-DOAS System

Application Of Stimulated Rotational Raman Scattering Technique In No2-Dial System

Experiment Study of SO2 Measurement by Differential Absorption Lidar

Amplitude Modulated Multimode-Diode-laser-based Cavity Enhanced Absorption Spectroscopy with a Phase-Sensitive Detection for High-Sensitivity NO2 Detection

Optimization of Raman Laser Recourse for NO_2-DIAL

Research on Vehicle-Mounted Measurement of NO 2 Based on Cavity Ring-Down Spectroscopy

A Rapidly Tunable TEA CO 2 Laser for Differential Absorption Lidar

[Open-path online monitoring of ambient atmospheric CO2 based on laser absorption spectrum]

The Application of Uniaxial Crystal Reflectivity in NO 2 -DIAL Optical Path

Development of a Rapid Measurement Method for Analysis of the NOx Conversion Process Based on Quantum Cascade Laser Absorption Spectroscopy

Amplitude-Modulated Cavity-Enhanced Absorption Spectroscopy with Phase-Sensitive Detection: A New Approach Applied to the Fast and Sensitive Detection of NO2

Design of a High-Spectral-resolution Lidar for Atmospheric Temperature Measurement Down to the Near Ground.

Design of a Data Acquisition, Correction and Retrieval of Na Doppler Lidar for Diurnal Measurement of Temperature and Wind in the Mesosphere and Lower Thermosphere Region

Development of A Portable Cavity-Enhanced Absorption Spectrometer for the Measurement of Ambient No3 and N2o5: Experimental Setup, Lab Characterizations, and Field Applications in A Polluted Urban Environment