Abstract:Recent progress on high efficiency Tm-doped silica fibers pumped at 790nm has enabled the demonstration of a 2 mu m CW fiber laser operating at the 1kW power level and with single mode beam quality [1]. In addition to this state-of-the-art high power research, Tm-doped fibers are now starting to find applications in lasers with nsec [2] and psec [3] pulsed operation, as well as lower power CW lasers (50-100W) in the 1940nm wavelength region for medical use [4].As with Yb-doped fibers, the question of photodarkening needs to be addressed to ensure the long term fiber reliability is appropriate for the application. In a recent paper [5], we proposed that the up-conversion process in highly doped Tm-fibers was significantly quenched when compared with lower concentration fibers, under 790nm pumping. This trend was also observed in the photodarkening rate as measured in a CW 2 mu m fiber laser cavity operating around 20W output power. In this controlled experiment, the rate of photodarkening dropped from 15% per 1000 hours in low concentration fiber to less than 1% in a fiber doped with 4.6% Tm.In this paper we review the 20W results of our earlier work and then confirm the long term reliability of 1940nm CW fiber lasers operating at higher (40W) output power, presenting results for a laser operating for 1200 hours without significant loss of output power (around 12% total power variation). Over any given 24-hour period during this experiment, the laser operates open loop with around 8% total power variation, in an air cooled configuration. We believe these results confirm the appropriate level of long term reliability of Tm-doped fibers for CW fiber lasers at the similar to 50W power level, suitable for medical laser applications.

Theoretical Study on the 1180nm Laser Pumped Tm,Ho Co-Doped Silica Fiber Laser

Theoretical modeling of Tm-doped silica fiber lasers

Effects of Ho3+-Doping Concentration on the Performances of Resonantly Pumped Ho:Yag Ceramic Lasers

Single-frequency fiber laser of 315 mW at 1940 nm based on a Tm : YAG/Ho : YAG-co-derived silica fiber

The comparative study of high efficiency of Tm^{3+}-doped fiber laser at 1.72 μm for different pump schemes

Energy Level Systems and Transitions of Ho:Luag Laser Resonantly Pumped by A Narrow Line-Width Tm Fiber Laser

Tm:Fiber Laser In-Band Pumped Ho:Luag Laser with over 18 W Output at 2124.5 Nm

Characterization of Holmium-Doped Fiber Using AOM and Considering Pair-Induced Quenching and Fiber Length

Tm-fiber Pumped Single-Longitudinal-mode Ho:LuVO 4 Laser

400 mW narrow-linewidth Tm-doped silica fiber laser output near 1750nm with volume Bragg grating

Efficient 2075-nm laser emission from Ho3+-doped fluorotellurite glass in a compact all-fiber structure

High-efficiency longwave 2085 nm laser output in low-loss Ho 3+ -doped fluorotellurite glass fiber by 1976 nm in-band pumping

High-Power, High-Energy Ho:Yag Oscillator Pumped by A Tm-Doped Fiber Laser

Experimental Research on High Power Tandem Pumped Fiber Laser with Homemade Gain Fiber

Tm-Doped Fiber Lasers: Fundamentals and Power Scaling

Reliability and Photodarkening in 790Nm-Pumped 2μm Fiber Lasers

1.7 µm gain-switched and mode-locked hybrid Tm-Ho codoped fiber laser signal generation and optimization

Ultra-short Wavelength Operation in Thulium-doped Silica Fiber Laser with Bidirectional Pumping

1010 nm Directly LD-Pumped 6kW Monolithic Fiber Laser Employing Long-Tapered Yb3+-Doped Fiber

Holmium Laser In-Band Pumped by A Thulium Laser in the Same Host of Yalo3

Absorption efficiency analysis and optical resonator simulation of Ho:YLF laser pumped with Tm:fiber laser