Abstract:Pipelines are widely used in energy power system including thermal power plants and nuclear power plants. In the power system, especially nuclear power plants, as thermal stratification characteristic of nonuniform temperature distribution in the pipe and thermal fatigue such as the low cycle thermal fatigue due to existence of the cycle thermal stress are inevitable, the pipe line system can be destroyed easily and thus affect the normal operation of the power plants. In order to study the pipeline thermal fatigue, the pipeline thermal stress needs to be calculated and therefore the temperature distributions especially the inner wall temperature was needed. The outer wall temperature and working fluid temperature can be obtained with installing measuring tools. The key and difficult point is the estimation of the inner temperature distribution of the pipe. At the same time, in the practical engineering, the pipeline structure with special safety requirements or higher requirements for structural completeness are not allowed to be destroyed by the measuring equipment. Based on the consideration above, this paper presents a method of solving the inverse heat conduction problem, which means the inner temperature distributions can be derived by the outer wall temperature distributions. For the pipe inverse heat conduction problem, this paper applies numerical analysis as the main way. Firstly, the method for transient inverse heat conduction problems applying separation of variables and Duhamel's theorem is established. As the effects of the random error on the measured outer wall temperature are inevitable, the measured data need to be smoothed before used as an input. The Gram orthogonal polynomial method based on the digital filtering theory is applied in this paper to accomplish the smoothing process. The inverse process is accomplished by using MATLAB programming. Then this method is verified in the experiment with high temperature and high pressure. In order to directly validate the accuracy of the inverse analysis, for the test section, not only the transient outer wall temperature and fluid temperature were measured, but also the time dependent middle layer temperature were measured. Then the middle layer temperature obtained from inverse calculation was compared with the measured data from the experiment. The calculated results show that the accuracy of this method is high. The temperature distributions along the radical direction can be obtained quickly and accurate instantaneous heat load for the structural stress analysis and thermal fatiglie analysis can be provided using this method. (CSPE)

NUMERICAL STUDY ON HEAT TRANSFER CHARACTERISTICS OF CONDUCTIVE MUD

Numerical Simulation and Analysis on the Heat Transfer of the Vertical Ground Heat Exchanger in Hydrous Soil

Numerical Investigation of Heat Transfer Characteristics in a Shell- And-Tube Latent Heat Thermal Energy Storage System

Numerical Simulation for Soil Temperature Field of Buried Oil Pipeline Considering Effects of Moisture

Numerical configuration design and investigation of heat transfer enhancement in pipes filled with gradient porous materials

Investigation into the Heat Transfer Models for the Hot Crude Oil Transportation in a Long‐buried Pipeline

MHD Convective Heat Transfer with Temperature-Dependent Viscosity and Thermal Conductivity: a Numerical Investigation

Numerical Simulation Analysis of Temperature Control of Large Volume Concrete Aqueduct

Experimental and numerical study on the attenuation and recovery characteristics of ground temperature during deep-buried pipe heat transfer

NUMERICAL INVESTIGATION ON THE EFFECTS OF VISCOUS DISSIPATION AND VARIABLE THERMO-PHYSICAL PROPERTIES ON FORCED CONVEC-TION HEAT TRANSFER IN POROUS MEDIA

Investigation of the Heat Transfer Performance of Multi-Borehole Double-Pipe Heat Exchangers in Medium-Shallow Strata

Transient Numerical Investigation of a Thermal-Driving Water Pipe Cooling System

Progress and Review on Numerical Calculation for Soil Temperature Field around Underground Oil Pipelines

Development of a Microstructure-Based Numerical Approach for Analyzing Heat Transfer Within the Asphalt Mixture

A Numerical Solution For The Transient Inverse Heat Conduction Problem

NUMERICAL ANALYSIS AND SIMULARITY EXPERIMENT ON TEMPERATURE FIELD OF UNDERGROUND PIPE

Numerical Research on Heat Transfer Characteristics of Evaporation Segment of Separate Type Heat Pipe

NUMERICAL SIMULATION OF ENHANCED CONVECTION HEAT TRANSFER USING METHANE-STEAM REFORMING IN CATALYST FILMS IN A VERTICAL TUBE

Numerical Investigation of High-Temperature Heat Pipes with Different Wick Structures under Non-Uniform Heating Boundary Conditions

Heat Charge Simulation Method to Calculate Steady-state Temperature Field of Underground Heat Pipe

Analyzing the thermal performance of transient heat transfer mechanism due to the combined effects of solar energy and variable surface temperature: Growing applications of solar energy in co-axial pipes