Abstract:Aiming at developing carbon fibre/polyamide-12 (CF/PA) composite powders for manufacturing high-performance components by selective laser sintering (SLS), the preparation, characteristics and sintering process of the composite powders and mechanical properties of sintered components were studied. Surfaces of the carbon fibres were treated by the oxidation modification and coated with polyamide-12 through the dissolution-precipitation process to provide good interfacial adhesion and homogenous dispersion within the polyamide-12 matrix. The particle size and micro-morphology analyses show that the CF/PA composite powders with 30 wt%, 40 wt% and 50 wt% carbon fibres present the suitable powder sizes and format for SLS. The incorporation of carbon fibres into the polyamide-12 matrix decreases the initial melting temperature and consequently lowers the SLS part bed temperatures, implying lower energy requirement and less thermal degradation in the sintering process. The CF/PA composites also represent higher thermal stability than the pure polyamide-12. The CF/PA sintered components with 30 wt%, 40 wt% and 50 wt% carbon fibres exhibit the greatly enhanced flexural strengths by 44.5%, 83.3%, 114%, and the flexural modulus by 93.4%, 129.4%, 243.4%, respectively, as compared with the pure polyamide-12 sintered parts. Fractured surface analysis shows that the carbon fibres are encapsulated and bonded well with the polyamide matrix. The complex SLS parts with the thinnest wall of 0.6 mm, the density of 1.09 +/- 0.02 g/cm(3) and the relatively density of 94.13 +/- 1.72% were manufactured using the CF/PA composite powder with 30 wt% carbon fibres. This study demonstrates that the CF/PA composite powders prepared by the surface treatment and dissolution-precipitation method represent suitable interfacial adhesion, filler dispersion, particle sizes and sintering behaviours for SLS and enable the manufacture of complex components with high performance. (C) 2011 Elsevier Ltd. All rights reserved.

Progress on Selective Laser Sintering of Polymers and Polymer Composites

Polymer Based Composites for Selective Laser Sintering 3D Printing Technology

Selective Laser Sintering of Polymer Based Nanocomposites

Advances in selective laser sintering of polymers

Application of Polymeric Materials in Selective Laser Sintering——(Ⅰ)Research Development of the Polymeric Materials

Preparation of Polymer /al_2o_3 Nano-composites by Selective Laser Sintering

Preparation, Characterisation and Processing of Carbon Fibre/polyamide-12 Composites for Selective Laser Sintering

Improvement on Selective Laser Sintering and Post-Processing of Polystyrene

Preparation of Ceramic Materials Used for Selective Laser Sintering and Related Forming Methods

Studies on 3D Printing of Polymer-based Micro/Nano Functional Composites

Process Study of Selective Laser Sintering of PS/GF/HGM Composites

Polymer Materials for Additive Manufacturing: Liquid Materials

Application of Polymeric Materials in Selective Laser Sintering——(Ⅱ)Effects of Polymer Characteristics on Forming

Progress in selective laser sintering of multifunctional polymer composites for strain- and self-sensing applications

A comprehensive review of polymer materials and selective laser sintering technology for 3D printing

A Novel Method Based on Selective Laser Sintering for Preparing High-Performance Carbon Fibres/polyamide12/epoxy Ternary Composites

Multiphase Polymeric Materials for Rapid Prototyping and Tooling Technologies and Their Applications

High Temperature Rheological Behavior and Sintering Kinetics of CF/PEEK Composites During Selective Laser Sintering

Current Status and Prospects of Polymer Powder 3D Printing Technologies

SELECTTVE LASER SINTERING TECHNOLOGY AND THE INFLUENCE OF POLYMERS USED ON THE TECHNOLOGY

Study on Performance of Metal and Polymer Composites Parts Based by Additive Manufacturing