Abstract:The mini-crack development around a prefabricated fracture cemented with grout in a plate specimen subjected to uniaxial compression is tested and studied under direct SEM observation. The rock used for the test is Fangshan marble, which is relatively homogeneous in texture. Its grain size is 0.05-0.35 mm, its elastic modulus is about 78.9 GPa, Poisson's ratio is 0.35 and uniaxial compressive strength is 160 MPa. The specimen is a plate 25 mm × 12 mm × 1.6 mm in size with a central slot about 0.6 mm wide and 6.0 mm long cemented with grout. The compressive strength of the cement grout is about one fifth of that of the marble. The major axis of the cemented fracture is inclined to the loading direction at 30°, 45° and 60°. The tests are carried out in the vacuum chamber of a SEM using a vise-type loading frame. Its loading capacity is 2000 N and the load on the specimen is measured by the piezoelectric transducer with a resolution of 0.5 N. The initiation, coalescence and recovery of mini-cracks are photographed and analyzed. The mini-cracks extend during the formation of a shear band composed of paralleled cracks, and then merge to form the fracture. The test results are compared with those with open fracture in the specimen from the previous study. It is observed that not only the load required for the crack initiation is higher, but also the crack initiation points move closer to the fracture ends in cemented fracture specimen. There are more multiply developed mini-cracks at the neighborhood of the fracture. The real fracture or fault system in earth, no matter at what scale, has lower strength, if it is filled with fault gouge or fault clay. Therefore, the test results gives a comprehensive picture for understanding and simulating the fracturing process in earth crust.

RESEARCH ON FRACTURING AROUND CEMENTED SLOT IN ROCK SPECIMEN

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Mesoscopic numerical test of crushing process of concrete under uniaxial compression

MINI-CRACK DEVELOPMENT FROM A CEMENTED FRACTURE IN MARBLE SPECIMEN UNDER UNIAXIAL COMPRESSION

Development of Subcracks Around Compound Fractures in Rock Specimens

Development of Subcracks Between En Echelon Fractures in Rock Plates

Experimental study on strain field evolution around a simulated thrust fault

Two-Dimensional Meso-Scale Simulation of Hydraulic Fracture in Concrete

An Experimental Study of the Strain Field Development Prior to Failure of a Marble Plate under Compression

Experiment and finite element simulation of X-type shear fractures from a crack in marble

Experimental study on strain field evolution around a simulated thrust faultKey points

Fracture behavior of cylindrical sandstone specimens with two pre-existing flaws: experimental investigation and PFC3D simulation

STUDY OF CONCRETE FRACTURE PROCESS ZONE BASED ON FICTITIOUS CRACK MODEL

Fracture Evolution and Energy Characteristics During Marble Failure Under Triaxial Fatigue Cyclic and Confining Pressure Unloading (FC-CPU) Conditions

Numerical and Experimental Assessment of the Sandstone Fracture Mechanism by Non-uniform Bonded Particle Modeling

Fracture Simulation of Concrete Beams to assess softening behavior by varying different fractions of Aggregates

Experimental Research on Time-Dependent Behavior of Crack Propagation in Jinping Deep Marble

Influence of Single Fracture Inclination on Fault

Experimental and numerical studies of brittle rock-like specimens with unfilled cross fissures under uniaxial compression

Simulation of the fracturing process in rocks with flaws using a novel continuous-discontinuous technique

Fractal evolution characteristics of fracture meso-damage in uniaxial compression rock masses using bonded block model