THE ANALYSIS OF MECHANICAL AND CHEMICAL FACTORS MAKING THE DIFFERENCE OF FAULT'S ACTION

Li Zhen-sheng,LIU De-liang,LIU Bo,YANG Qiang

DOI: https://doi.org/10.3969/j.issn.1672-1926.2005.04.016

2005-01-01

Abstract:Mechanical and chemical factors, which influence fault′s action to fluid, are detailed discussed in this paper. The mechanical factors include mechanical property of fractures, normal stress of fault plane and deformation mechanism of faults, and their actions are as follows: ①The open degree of fault is determined by mechanical property of fractures and normal stress of fault plane; ②It has been testified by tri-axial compression experiments that the higher temperature and pressure, the deeper the deformation degree, the less porosity and permeability, but there is dilatancy during brittle deformation in low pressure. The dilatancy is reduced with the increase of effective stress. The chemical factors include chemical precipitation, pressure solution and element migration, and their actions are as follows: ① Chemical precipitation develops in unsealing fault; ②The development of pressure solution increases with the increase of temperature and pressure, and weakens with moisture content. ③Volume loss and element migration happen during deformation and metamorphism to form fault rocks, and most of volume loss is caused by pressure solution and element outmigration. The quantities of volume loss and element migration vary with deformation degree, for example, their correlation is positive in brittle-ductile Shuangshan fault. In F1 fault of Shuangshan fault, whose metamorphic grade is higher, the volume loss is as high as 50%, but in F2 fault, whose metamorphic grade is lower, it is only 8%. The regularity of element migration varies with mechanical property of faults, and it is as follows: the content of SiO~2 increases and coefficient of oxidation decreases from the margin to the center in compressive faults, and on the contrary in shear and tensile faults. In different mechanical faults, the influence degree of each factor is different. The comparing precondition is the assumption that faults form in the same stress field and their original rocks is the same. In compressive fault, there is relatively high temperature and pressure, closed fractures and fault plane, and high deformed and metamorphic grade; Pressure solution develops. Compressive fault zone is closed system whose reactions mostly are reduction and dehydration. In tensile fault, there is relatively low temperature and pressure, open fractures and fault plane; pressure solution doesn′t develop and chemical precipitation develops. Tensile fault zone is open system whose reactions mostly are oxidization and hydrolyzation. The aperture of fracture and fault plane in shear fault is intervenient between that in compressive and tensile faults. In the center of shear fault, pressure solution develops and deformed and metamorphic grade is high because of shear heats, and its sealing capacity is better; to its margin, fractures develop, sealing capacity weakens and flowing capacity increase gradually. Shear fault zone is open system in vertical.