Petrological and Geochemical Characteristics and Deformation Behavior of the Beichuan Section of the Wenchuan Earthquake Fault Zone

Li ChengLong,Li HaiBing,Wang Huan,Zhang JinJiang

DOI: https://doi.org/10.18654/1000-0569/2021.10.11

IF: 1.468

2021-01-01

Acta Petrologica Sinica

Abstract:Rock composition, internal structures and geochemical properties of a fault zone are three critical aspects for the understanding of its nature of fault activities and deformation behaviors. Fault gouge, as a key component of a fault zone, not only determines the strength of a fault zone, but also controls its slip mechanism. In this study, we focused on the fault gouge in the Shaba trench in the Beichuan section of the Yingxiu-Beichuan fault zone. Based on macroscopic and microstructural observation, X-ray diffraction (XRD), TESCAN Integrated Mineral Analyzer (TIMA) and micro X-ray fluorescence (mu XRE) analyses, we systemically dissected the nature of fault gouge, and discussed its deformation behaviors and faulting mechanisms related to the fault zone. Our research results show that the fault core in Beichuan section consist of foliated black fault breccia and fault gouge. Among which, a 25-cm-thick fault gouge belt is layered by yellow, gray and black fault gouges. The Wenchuan earthquake slipping zone was lying in the border of the gray and black fault gouges, where drag structures and R1 secondary shear fractures are visible around the slip zone, indicating a characteristic of thrust slipping. The clasts in the fault gouge are angular with varying sizes, showing the characteristics of rapid seismic sliding. The yellow and gray fault gouges contained much more clay minerals (42% similar to 52%) than the black one (19% similar to 29%), and their quartz (36% similar to 47%), illite (18% similar to 32%) and chlorite (7% similar to 15%) contents are also higher, while the feldspar content is lower than that of the latter. These may indicate that water-rock interaction in yellow and gray fault gouge was stronger than in the black fault gouge, suggesting that the porosity of the former gouge is higher than that of the latter. Highly enriched illite/smectite formation and Fe element in the slip zone imply friction heat was generated during the slip. Meanwhile, graphite was emerged in the black fault gouge, which indicates that thermal pressurization occurred as a weakening mechanism during the fault sliding. In the Yingxiu-Beichuan fault zone, obvious differences in rock compositions and fault zone scales were observed between the southern segment in the Hongkou area and the northern segment in the Beichuan section. However, fault gouge graphitization exists in both sections. Together, the systemic investigations have important implications for understanding the faulting behavior of the northern and southern segments of the Yingxiu-Beichuan fault zone.