Abstract:In this paper, a model of flood area display and damageevaluation is discussed, which adopts seed spread algorithm to calculate and visualize flood area based on a DEM data set and under the condition of a given water level of flood. The raster image containing flood area is overlaid with raster data converted from thematic vector maps such as land-use map and related to other socio-economic data, and then quantitative evaluation of flood damage is achieved. There are two different cases, the so-called “non-source flood” and “source flood”, for determining flood area based on DEM and under the given water level condition. Non-source flood corresponds to the case with well-distributed and large-area rainfall where all the low-lying land may have a flood disaster, and in this case all the points with elevations below the given water level should be included in the flood area. The “source flood” is the case of flood (e.g. from bank burst) flushing through the surrounding lands that needs to consider “ci rculating” condition. Because flood may be obstructed by ring structures or high lands, thus it can only cover the place where it flows and reaches. One of the computer processing methods suitable for source flood is the seed-spread algorithm. The principle of this method is to select a representative pixel as a seed and to examine its contiguous pixels outward along 4 or 8 directions. The pixels, contiguous to it and meeting the given conditions, become seeds, and then contiguous pixels to the new seeds will be examined in the same way. This process repeats until an aggregation of the pixels which meet the given conditions on a certain plane are obtained. Adopting seed spread algorithm for source-flood area calculation is just to achieve an aggregation of pixels, which satisfies the connectivity requirement and the given conditions of water level. The initial position of seed pixel should usually be selected on the characteristic points, e.g. adjacent to a reservoir dam or stream boundary. The precision of flood area calculation is mainly determined by spatial resolution of the DEM, the area on the ground is represented by each pixel; whereas the accuracy of flood area calculation, to a great extent, is dependent on the preci sion of the DEM's pixel value or elevation.Once the area below the flood water level has been calculated, the flood damage evaluation can be calculated by overlaying the flood range with thematic maps and by relating to other socio-economic data. All thematic maps were converted to raster data because algorithm of the overlay analysis implemented in raster format is relatively simple and computing is fast. In order to improve accuracy of the flood damage evaluation it is necessary to accurately register and georefer all raster layers before overlay analysis. The calculation results of flood damage evaluation are generally represented by tabulation, which is a kind of classified statistics of flood damage data, e.g. a table representing total area of every land-use type in different administrative divisions. The results of flood area calculation and damage evaluation can also be visually and dynamically provided in the forms of graph, image, 3D or virtual reality. The model has been successfully applied in the “Zhejiang Provincial Water Conservancy Management System” developed for a national project.

Flood hazard analysis method based on complex network approach and its application

A Dual-Layer Complex Network-Based Quantitative Flood Vulnerability Assessment Method of Transportation Systems

Flood risk cascade analysis and vulnerability assessment of watershed based on Bayesian network

The value to medical practice of basic and applied medical research done twenty years ago.

A GIS-based Method for Flooded Area Calculation and Damage Evaluation

A novel integrated urban flood risk assessment approach based on one-two dimensional coupled hydrodynamic model and improved projection pursuit method

Flood risk assessment in metro systems of mega-cities using a GIS-based modeling approach

A GIS Based Model for Calculating of Flood Area

Enhancing Flood Risk Assessment and Mitigation Through Numerical Modeling: A Case Study

Micro-scale Flood Hazard Assessment Based on Catastrophe Theory and an Integrated 2-D Hydraulic Model: A Case Study of Gongshuangcha Detention Basin in Dongting Lake Area, China

Flood Submergence Simulation and Risk Analysis Based on GIS in Plain Area

Comprehensive flood risk assessment based on set pair analysis-variable fuzzy sets model and fuzzy AHP

An integrated model chain for future flood risk prediction under land-use changes

Case-based risk analysis model for rainstorm inundation in metro systems based on a bayesian network

Modeling flood induced interdependencies among hydroelectricity generating infrastructures

An Improved Fineness Flood Risk Analysis Method Based on Digital Terrain Acquisition

Regional flood risk assessment based on fuzzy cluster factor analysis

Flood Risk Assessment Based on Fuzzy Synthetic Evaluation Method in the Beijing-Tianjin-Hebei Metropolitan Area, China

Urban flood risk assessment characterizing the relationship among hazard, exposure, and vulnerability

Urban Flood Risk Assessment in Zhengzhou, China, Based on a D-Number-Improved Analytic Hierarchy Process and a Self-Organizing Map Algorithm

Flood risk assessment of urban metro system using random forest algorithm and triangular fuzzy number based analytical hierarchy process approach