Abstract:The 12 February 2018 MW4.3 Yongqing earthquake, is the largest shock around the Beijing area since the 2006 Wen'an MS5.1 earthquake.Similar to the 2006 Wen'an earthquake and many other earthquakes in this region, very few aftershocks were recorded after the Yongqing mainshock.It raises a question whether the isolated earthquake sequence is related or not to the source characteristics.To answer this question, investigations of the source mechanism and rupture process are necessary.We estimated the moment tensor solution and rupture process by inverting seismograms of 38 local broadband stations within the epicentral distances of 200 km.The duration and shape of the source time function were considered in the moment tensor inversion.Through a grid search, we found a centroid depth of about 16 km of the earthquake.The scalar seismic moment is 3.1×1015 Nm, equivalent to amoment magnitude MW4.3.From the source time functions, the rupture duration is about 3.5-4.0 s.The mechanism solution suggested a strike slip event, with a minor normal-faulting component.Combined with the geological background, the NE striking and SE dipping nodal plane was identified as the causative fault.The rupture model was estimated on the NE striking fault plane by using a linear technique.From the static slip distribution, the peak slip is about 1.3 cm, and the rupture dimension is approximately 2 km.Most slips are concentrated around the major slip asperity.The source time function suggests a source duration of about 3.5 s, and the peak moment rate appearing at 1 s, which are well consistent with those from the moment tensor inversion.The earthquake ruptures expanded from the hypocenter in a circular dislocation model at 0-2 s.A few weak slips appeared at shallow depth after 2 s, which might be caused by errors in observation and Green's functions and were less reliable.Both the peak slip and the rupture dimension of the 2018 Yongxing earthquake are higher than the values of an MW4.3 earthquake estimated from existing earthquake scaling law.They may provide additional constraints for further correction of the parameter-magnitude scaling laws.The maximum and average stress drops are about 0.6 and 0.3 Mpa, respectively, remarkably lower than 10 Mpa of a typical intraplate earthquake.The relatively low stress drop indicates that the fault strength is weak.Seismic tomography in the Huabei area has found that the crust is fractured, which may lead to weak faults there.The fractured crust and weak fault can block the stress transformation to some extent, and are likely to cause isolated earthquake sequence.

Variations in Apparent Stress of Ms4.3 Seismic Sequence in Badong County in June, 2017

Ground motion simulation for the 21 May 2021 Ms 6.4 Yangbi, China, earthquake using stochastic finite-fault method

APPARENT STRESS VARIATION CHARACTERISTICS BEFORE AND AFTER BADONG EARTHQUAKE IN THE THREE GORGES RESERVOIR AREA

Comparative Study of Seismic Sequence of 2014 Zigui M4.7, M4.5and 2017 Zigui-Badong M4.3, M4.1 Earthquakes

Spatial and Temporal Variations of Stress Field in the Longmenshan Fault Zone after the 2008 Wenchuan, China Earthquake

Analysis of the Badong Ms5. 1 Earthquake Source Characteristics

Stress analysis for the seismogenic mechanism of the Yangbi Ms6.4 earthquake sequence in May 2021

Mann-Kendall Mutation Analysis of Temporal Variation of Apparent Stress in Qinba Mountains and Its Adjacent Areas

USING SEISMIC DATA FROM A SINGLE-STATION TO CALCULATE THE FOCAL MECHANISMS OF THE AFTERSHOCKS OF THE Ms6.3 DACHAIDAN EARTHQUAKE IN NOV.10,2008

The Focal Depths of the 2008 Panzhihua Earthquake Sequence and the Stress Field in the Source Region

Characteristics analysis of tectonic stress field around the Mojiang earthquake and its adjacent areas on September 8, 2018

An updated stochastic finite fault modeling: Application to the M w 6.0 earthquake in Jiashi, China

Research on Double-difference Relocations and Focal Mechanism Solutions of the 2014 Yunnan Jinggu Ms6.6 Earthquake Sequence

Focal Mechanisms of the Lushan Earthquake Sequence and Spatial Variation of the Stress Field

Source mechanism and rupture characteristics of the 2018 MW4.3 Yongqing earthquake

Earthquake Focal Mechanisms in Yunnan and Their Inference on the Regional Stress Field

Study on 3-D velocity structure around the focal region of the Anqing earthquake in January 2011 and its causative fault

Regional Characteristics of Seismicity Associated with Hydraulic Fracturing in the Southern Sichuan Basin of China

Rupture characteristics of the MS4.6 Ruichang-Yangxin earthquake of Sep.10,2011 and the strong earthquake risk in the region

Aftershock Sequence of the 2017 M W 6.5 Jiuzhaigou, China Earthquake Monitored by an AsA Network and Its Implication to Fault Structures and Strength

Source Scaling, Spatially Variable Path Attenuation, and Site‐Effect Parameters via a Generalized Inversion Technique for Strong‐Motion Data from Sichuan, China