Source mechanism and rupture characteristics of the 2018 MW4.3 Yongqing earthquake

Yong Zhang,Yuntai Chen,Jin Song

DOI: https://doi.org/10.1360/N972018-00364

2018-01-01

Chinese Science Bulletin

Abstract:The 12 February 2018 MW4.3 Yongqing earthquake, is the largest shock around the Beijing area since the 2006 Wen'an MS5.1 earthquake.Similar to the 2006 Wen'an earthquake and many other earthquakes in this region, very few aftershocks were recorded after the Yongqing mainshock.It raises a question whether the isolated earthquake sequence is related or not to the source characteristics.To answer this question, investigations of the source mechanism and rupture process are necessary.We estimated the moment tensor solution and rupture process by inverting seismograms of 38 local broadband stations within the epicentral distances of 200 km.The duration and shape of the source time function were considered in the moment tensor inversion.Through a grid search, we found a centroid depth of about 16 km of the earthquake.The scalar seismic moment is 3.1×1015 Nm, equivalent to amoment magnitude MW4.3.From the source time functions, the rupture duration is about 3.5-4.0 s.The mechanism solution suggested a strike slip event, with a minor normal-faulting component.Combined with the geological background, the NE striking and SE dipping nodal plane was identified as the causative fault.The rupture model was estimated on the NE striking fault plane by using a linear technique.From the static slip distribution, the peak slip is about 1.3 cm, and the rupture dimension is approximately 2 km.Most slips are concentrated around the major slip asperity.The source time function suggests a source duration of about 3.5 s, and the peak moment rate appearing at 1 s, which are well consistent with those from the moment tensor inversion.The earthquake ruptures expanded from the hypocenter in a circular dislocation model at 0-2 s.A few weak slips appeared at shallow depth after 2 s, which might be caused by errors in observation and Green's functions and were less reliable.Both the peak slip and the rupture dimension of the 2018 Yongxing earthquake are higher than the values of an MW4.3 earthquake estimated from existing earthquake scaling law.They may provide additional constraints for further correction of the parameter-magnitude scaling laws.The maximum and average stress drops are about 0.6 and 0.3 Mpa, respectively, remarkably lower than 10 Mpa of a typical intraplate earthquake.The relatively low stress drop indicates that the fault strength is weak.Seismic tomography in the Huabei area has found that the crust is fractured, which may lead to weak faults there.The fractured crust and weak fault can block the stress transformation to some extent, and are likely to cause isolated earthquake sequence.