Abstract:Use of maximum likelihood estimation procedures with multiple imputations to replace observations below the limit of detection (LOD) has been recommended. There is concern that the use of multiple imputations may introduce variability in the data resulting in different conclusions every time the same data are statistically analyzed. We analyzed data from National Health and Nutrition Examination Survey for 7 perfluorinated and 7 polybrominated diphenyl ethers to address these concerns. Data for each variable were subjected to 10 different iterations of statistical analysis. All observations below LOD were replaced by maximum likelihood estimation procedures with 5 imputations. The maximum variation in computing unadjusted geometric means over 10 iterations of analysis was about 2.5%. Unless the percent observations below LOD was more than 40%, maximum variation in computing adjusted geometric means was less than 1.5%. Maximum variation for computing adjusted geometric standard deviation was less than 6%. Except for border line comparisons, significance probabilities for pairwise comparisons did not vary enough to render contrasts from being statistically significant to statistically non-significant or vice versa. Similar conclusions applied to significance probabilities for regression slopes. The use of more than one multiply imputed variable in a regression model was not found to be of concern. The results show that the use of multiple imputations does not generate additional variabilities in the estimates of these statistics beyond tolerable statistical noise. However, when the percent observations in the data are relatively high, there is some possibility of obtaining disparate results.

Application of Maximum Likelihood Estimation in Analysis of the Values Less Than Detectable Limit

[Application of multiple limits regression in dealing with nondetects with multiple limits of detect].

Application of Number Theoretic Methods in Maximum Likelihood Estimation

Maximum-likelihood Mixture Factor Analysis Model and Its Application for Process Monitoring

Tilting maximum Lq-Likelihood estimation for extreme values drawing on block maxima

Preliminary application of maximum likelihood method in HL-2A Thomson scattering system

Application of Maximum Entropy Probability Density Estimation Approach to Constituting Oil Monitoring Diagnostic Criterions

Maximal likelihood estimate of life data of environment-protecting and energy-saving lights based on Weibull-distributing

A Modified Uncertain Maximum Likelihood Estimation with Applications in Uncertain Statistics

Essential formulae for restricted maximum likelihood and its derivatives associated with the linear mixed models

Maximum Approximated Likelihood Estimation

Introduction to the Methods of Parameter Estimation for Environmental Monitoring Data Set with Truncated Data below a Detection Limit

Application of Maximum Likelihood Estimation Model in X - MR Control Charts

A New Maximum Entropy Method for Estimation of Multimodal Probability Density Function

A method of maximum likelihood fit to data with non-uniform efficiencies

On the consequence of substituting maximum likelihood estimates for the observations below the limit of detection

Maximum Likelihood Estimation Of Double Alternative Step-Stress Accelerated Life Test For Electronics

Measurement uncertainty evaluation for a non-negative measurand: an alternative to limit of detection

Existence of Maximum Likelihood Estimation for Three-Parameter Log-Normal Distribution

Uncertain Maximum Likelihood Estimation with Application to Uncertain Regression Analysis

Detecting Rare and Faint Signals Via Thresholding Maximum Likelihood Estimators