Abstract:Objective To explore the effect of different scan parameters and algorithm on detection of iron deposition with coexsiting fat by dual soure CT.Methods One ml homogenate of normal rat liver tissues and 1 ml iron dextran solution with different concentrations (50.000,25.000,12.500,6.250,3.125,and 1.560 mg/ml) were fully mixed respectively.The 6 test tubes were scanned by dual source CT in the mode of dual energy to gain the iron specific slope.Different concentrations of dextran iron(50,40,30,20,10,and 5 mg/ml),triglyceride(volume percent were 60％,30％,and 10％,respectively),and homogenate of normal rat liver tissues were mixed.All 18 tubes were scanned by dual source CT with 80-140 kVp and 100-140 kVp,and all these images were reconstructed by filtered back projection (FBP) and singogram affirmed iterative reconstruction(SAFIRE).Raw data were reconstructed by filtering and iterative method.△H value (△H =CT value low kVp-CT valuehigh kVp) and overlay value of three substances decomposition algorithm were measured and analyzed by t test.The Spearmen correlation was applied in iron concentration and measured values.Results Iron specific slope was found to be 1.9392.When 80-140 kVp and 100-140 kVp were applied,△H values were (198 ± 28) and (152 ± 18) HU by using FBP reconstruction,and △H values were (191 ± 23) and (149 ± 17) HU by using SAFIRE reconstruction.The differences were statistically significant(t =-2.934 and-3.492,P =0.032 and 0.017).Overlay values were (381 ±54) and (236 ±31) HU by using FBP reconstruction,and overlay values were (399 ±53) and (276 ± 43) HU by using SAFIRE reconstruction.The differences were also statistically significant (t =-5.739 and-7.949,P =0.002 and 0.001).Under the same energy portfolio but different reconstruction,both △H and overlay value showed no differences (P ＞ 0.05).Except for the conditions with 100-140 kVp tube voltage,△H had no correlation with iron solution concentration (P ＞ 0.05) under either FBP or SAFIRE reconstruction.When other reconstruction methods and tube voltage combination were used,overlay or △H value showed correlation with iron solution concentrations (r value ranged from 0.959 to 0.997,P values ＜ 0.01).Conclusions Different energy portfolios of dual source CT will act on the measured value of iron deposition.The measured values will not be affected by ways of reconstruction.For the detection of iron coexisting in fat,overlay values of material decomposition algorithm is better.

Iron dextran peak molecular weight comparison determination in iron dextran injections

Analysis of the Effect of Iron Dextran Oral Liquid on Pediatric Nutritional Iron Deficiency Anemia

HPLC determination of DL111-IT injections and its related impurities

Comparison on serum iron concentration and toxicity for two kinds of iron dextran preparations

Removal of Iron Dextran During Hemodialysis with Polysulfone F6 and Homophone GFSplus12

Quantitative Analysis Combined with Chromatographic Fingerprint for Comprehensive Evaluation of Danhong Injection Using HPLC-DAD

Study of Relative Molecular Mass of Polymers in Qingkailing Injection by High Performance Gel Permeation Chromatography

Comparison of Therapeutic Efficiency Between Saccharum Iron and Ferrum Dextran Iron: a Multicenter Clinical Trial

Effects of molecular weight of dextran on the rheological behavior and texture properties of soy protein isolate cold-set gels

Characterization Of Destrins With Different Dextrose Equivalents

A High-Performance Liquid Chromatography Method for the Simultaneous Determination of Five Index Components in Danhong Injection

Preparation and Evaluation of Dextran-Grafted Agarose Resin for Hydrophobic Charge-Induction Chromatography.

An Analytical Method for Determination of Total Iron in Pharmaceuticalgrade Intravenous Iron Colloidal Complexes by Redox-Potentiometry

Determination of disialoganglioside GD3 and monosialoganglioside GM3 in infant formulas and whey protein concentrates by ultra-performance liquid chromatography/electrospray ionization tandem mass spectrometry.

Evaluation of the efficiency and safety of the compound dextran 40 injection used in the operation

Determination of parameters in dextran gel filtration

Rheological Properties of Soybean Beta-conglycinin Gels with Different Molecular Weight Dextrans

Effect of Different Scan Parameters and Algorithm on Detection of Iron Deposition Coexiting in Fat by Dual Source CT

Quantitative Analysis Of Iron In Protein Bands Existing In Polyacrylamide Gel Matrix With Synchrotron Radiation X-Ray Fluorescence

Comparison of Superdex Peptide HR 10/30 Column and TSK Gel G2000 SWXL Column for Molecular Weight Distribution Analysis of Protein Hydrolysates

Clinical dextran purified by fractional ultrafiltration coupled with water washing