3D Finite Element Method Analysis of Jointed Rock Slope Reinforced by Multiple Structures

Xing ZHANG,Bo ZHOU,Hua-bin WANG,Ying-zhi GAO
DOI: https://doi.org/10.3969/j.issn.2095-0985.2017.06.019
2017-01-01
Journal of Civil Engineering and Management
Abstract:Reinforced structures for large-scale jointed rock slopeshave become an important issue in the engineering design and research. This paper aimed to optimize the measurement for a complex landslide after analysis about a cutting slope as K104+946 in the Highway range from Enshi, Hubei to Qianjiang and Chongqing, including anti-sliding piles, retaining wall and anchoring. Firstly, numerical simulation models were constructed using a commercial software as ABAQUS in different cases. In these models, stability factors were calculated using the strength reduction method, which paid much attention to the slope joints. The interaction between anti-slide piles, retaining wall and anchor-bars were then discussed. It was found that the upper slope and lower slope is mainly supported by the anchor-bar and the anti-slide pile, respectively. The retaining wall can slightly bear the soil pressure from the anchor-bar and anti-slide piles. Furthermore, the relationship between stability factors and pile location, spacing and diameters were analyzed by numerical simulations. The simulation results show that the optimized support case is that piles are better to be located in front of the slope, pile spacing is about 2.5 to 4 times of the pile diameter. For the pile diameter optimization, the value can be chosen in length and width as 1.4 m × 2.1 m or 1.6 m×2.4 m.
What problem does this paper attempt to address?