Abstract:Particulate deposition has become a significant challenge of developing more efficient film cooling configurations for hot turbine components. To assess the influence of particulate deposition and to better understand the coupling effects of deposition evolution and film cooling, experimental simulations were conducted by injecting low-melting-point wax particles into a low-temperature wind tunnel facility, in which the particle transport and sticking behaviors were properly modeled by matching critical non-dimensional parameters in engine conditions. The sensitivity of film cooling to deposition was assessed on flat plates with a row of simple-angled film holes and compound-angled film holes, respectively. Local deposition patterns were obtained using an optical profile scanner and an infrared thermography technique was implemented to quantify the development of film cooling with the evolution of deposition. Further, flow fields downstream of the holes and coolant trajectories were visualized by means of a five-hole probe and a schlieren photography technique, offering the flow physics backing the observation of film cooling. Inspection of deposition over the flat plates revealed that film cooling was helpful to inhibit deposition, which leads to sparse deposition near the hole exit and dense deposition elsewhere. Film injection from the compound-angled hole was found to be more sensitive to deposition, resulting in decreased cooling effectiveness regardless of coolant blowing conditions. In contrast, deposition reduced film cooling from the simple-angled hole at lower injection rates and then improved film cooling at higher injection rates. Globally, the compound-angled hole exhibited a maximum reduction of 20 % in cooling effectiveness, while that for the simple-angle hole was 8.5 % at an injection ratio of 0.5; and at a high injection ratio of 2.0, an improvement of 13.6 % was obtained, on the contrary.

Deposition characteristic of the oil droplet on housing in a bearing chamber

Investigation on sealing gap between ring gear and case in internal gear machines

Analysis of oil shedding and ligaments formation on bearing rotary elements

Analysis of Oil-Air Two-Phase Flow Characteristics inside a Ball Bearing with Under-Race Lubrication

Droplets impact on rotating cylinders

Simulation and Experimental on Thermal Behavior of Hydrostatic Thrust Bearing Based on Superhydrophobic/oleophobic Surface

Relationship between deposition properties and operating parameters for droplet onto surface in the atomization impinging spray

Analysis of Circulation Characteristics and Heat Balance of High-Speed Rolling Bearing under Oil-Air Lubrication

Effects of oil-air lubrication methods on the internal fluid flow and heat dissipation of high-speed ball bearings

Study of oil droplet patterns and laws of motion based on multi-field synergistic effects

Droplets bouncing on rotating curved surfaces with elevated temperatures

Experimental assessment of film cooling from cylindrical holes subject to particulate deposition

Experimental Investigation of Lubrication Oil Film Dynamics in a Typical Aero-Engine Bearing Chamber Environment

Direct Observation of the Impact of Water Droplets on Oil Replenishment in EHD Lubricated Contacts

Numerical Investigation for Characteristics and Oil–air Distributions of Oil Film in a Tilting-Pad Journal Bearing

Spontaneous process of dispersed salt water droplets in lubricant oil establishing wetted areas: Settling, spreading, coalescing and de-wetting

Study on Wax Deposition Process of Crude Oil System under Shear Flow Field Conditions

Expanding the microalgal industry--continuing controversy or compelling case?

Wetting Dynamics Behavior of In Situ Generated Droplet on Micropore Surfaces

The investigation of evaporation behavior of lubricating oil droplet at high ambient temperature

The Influence of Oil Film Thickness on the Gear Impact Dynamics of Friction Disc