Abstract:In this paper, a fixed-point finite impulse response adaptive filter is proposed using approximate distributed arithmetic (DA) circuits. In this design, the radix-8 Booth algorithm is used to reduce the number of partial products in the DA architecture, although no multiplication is explicitly performed. In addition, the partial products are approximately generated by truncating the input data with an error compensation. To further reduce hardware costs, an approximate Wallace tree is considered for the accumulation of partial products. As a result, the delay, area, and power consumption of the proposed design are significantly reduced. The application of system identification using a 48-tap bandpass filter and a 103-tap high-pass filter shows that the approximate design achieves a similar accuracy as its accurate counterpart. Compared with the state-of-the-art adaptive filter using bit-level pruning in the adder tree (referred to as the delayed least mean square (DLMS) design), it has a lower steady-state mean squared error and a smaller normalized misalignment. Synthesis results show that the proposed design attains on average a 55% reduction in energy per operation (EPO) and a $3.2\times $ throughput per area compared with an accurate design. Moreover, the proposed design achieves 45%–61% lower EPO compared with the DLMS design. A saccadic system using the proposed approximate adaptive filter-based cerebellar model achieves a similar retinal slip as using an accurate filter. These results are promising for the large-scale integration of approximate circuits into high-performance and energy-efficient systems for error-resilient applications.

Pulse shaping filter design based on improved DA algorithm

The Design and Implementation of Fir Filter Based on Improved Da Algorithm

Improved Design Scheme of High Accuracy Harmonic Detection Based on DSP

Implemented Architecture Design of Deblocking Filter for H.264

An Improved Algorithm for DSP Implementation of Boost PFC Converter

Compact resampling algorithm and hardware architecture for paticle filters

A Resource-efficient FIR Filter Design Based on an RAG Improved Algorithm

An Improved Harmonic Detection Based On Lead Compensation For Active Power Filter

Delineation of Optimized Single and Multichannel Approximate DA-Based Filter Design Using Influential Single MAC Strategy for Trans-Multiplexer

A Flexible Design for Optimization of Hardware Architecture in Distributed Arithmetic based FIR Filters

Design of an adaptive signal shaping filter in high dynamic measurement systems

A High-Performance and Energy-Efficient FIR Adaptive Filter Using Approximate Distributed Arithmetic Circuits

Time Delay Compensation Based on Phase-Shifting for Active Power Filter

Modeling and simulation of FIR filter using distributed arithmetic algorithm on FPGA

An Improved Area-Efficient Design Method for Interpolation Filter of Sigma-Delta Audio DAC

Optimized Design of FIR Filter Based on FPGA

TAFA: Design Automation of Analog Mixed-Signal FIR Filters Using Time Approximation Architecture

High throughput and energy efficient FIR filter architectures using retiming and two level pipelining

Time-Frequency Well-Localized Pulse Shaping Filter Design for High Speed Data and Multi-Carrier System Based on DPSS

An Optimized Design for a Decimation Filter and Implementation for Sigma-Delta ADC

A Down-Sample Design under Special Condition in High-Speed All-Digital System