Abstract:Lean-burn natural-gas spark-ignition combustion inside a diesel geometry is characterized by two distinct and successive events: a rapid burning process inside the piston bowl, followed by a much slower burn inside the squish region. This paper used experimental data (including images of flame natural luminosity) to investigate the magnitude and phasing of these two combustion stages. The results showed a substantial impact on the parameters generally used to investigate the combustion phenomena in spark-ignition engines (e.g., the 10-to-90-percent energy release). A better solution to identify the start and end of the rapid- and the slow-burning stages in such an engine is to use the inflection points in the apparent rate of heat release. Moreover, as the higher turbulence in a diesel-like environment accelerates flame inception, the 5% or 10% energy release used traditionally to define the flame inception period should not be used for these engines because the enflamed zone already reached an appreciable size at the two corresponding crank angle degrees. Further, the 2nd inflection point in the apparent rate of heat release (i.e., the point where the slow-burning stage started to dominate the heat release) was much advanced compared to 90% energy release generally used to define the end of the rapid-burning stage in conventional stoichiometric spark-ignition engines. Furthermore, as the slow-burning stage was characterized by a lower flame propagation speed, a lower fuel fraction burning during this stage would increase the engine combustion efficiency. Furthermore, a more advanced phasing of the late-burning stage relative to the fast-burn stage would result in a more optimal combustion environment (i.e., higher in-cylinder pressure and temperature), which would further improve the engine efficiency and probably reduce carbon monoxide and unburned hydrocarbon emissions. As a result, this study suggests that the combustion strategy of such converted diesel engines should advance and optimize the mass of fuel that burns inside the squish region.

Combustion characteristics in glow-plug ignition miniature ICE and influence of residual gas

Effect of Spark Timing on the Combustion Stages Seen in a Heavy-Duty Compression-Ignition Engine Retrofitted to Natural Gas Spark-Ignition Operation

Analysis of Two-Stage Natural-Gas Lean Combustion Inside a Diesel Geometry

Effect of Bowl-in-Piston Chamber on the Combustion Process in a Stoichiometric Natural-Gas Spark-Ignition Engine

An Experimental Investigation of Early Flame Development in an Optical Spark Ignition Engine Fueled with Natural Gas

Two-Stage Lean-Burn Combustion Inside a Natural-Gas Spark-Ignition Engine with a Bowl-in-Piston Chamber

An Experimental Study of the Combustion Process in a Natural-Gas Spark-Ignition Engine

Needle anxiety in the clinic: a needs assessment.

Investigation of Multistage Combustion Inside a Heavy-Duty Natural-Gas Spark-Ignition Engine Using Three-Dimensional Computational Fluid Dynamics Simulations and the Wiebe-Function Combustion Model

Twin-Peak Heat Release Phenomenon Inside a Heavy-Duty Diesel Engine Retrofitted to Natural-Gas Spark Ignition

Experimental Study of Glow Plug Assisted Compression Ignition

Experimental Combustion Analysis in a Gasoline Baseline Hydrogen-Fueled Internal Combustion Engine at Ultra-Lean Conditions

Low-Temperature Reforming Products coupling Spark Plug on Gasoline Compression Ignition and Combustion Characteristics under Low-Load Condition

Combustion stability control of gasoline compression ignition (GCI) under low-load conditions: A review

Optical analysis of flame inception and propagation in a lean-burn natural-gas spark-ignition engine with a bowl-in-piston geometry

Sequenced Combustion Characteristics, Emission and Thermal Efficiency in Gasoline Homogeneous Charge Induced Ignition

Effect of Octane Number and Thermodynamic Conditions on Combustion Process of Spark Ignition to Compression Ignition Through a Rapid Compression Machine

Investigation on Effects of Ignition Configurations on Knocking Combustion Using an Optical Rapid Compression Machine under Lean to Stoichiometric Conditions

Experimental Investigation about the Effect of Double-Spark Plug Ignition on Combustion Characteristics for Motorcycle Gasoline Engines with a Mild Lean Mixture

Combustion partitioning inside a natural gas spark ignition engine with a bowl-in-piston geometry

Effect of piston bowl geometry and compression ratio on in-cylinder combustion and engine performance in a gasoline direct-injection compression ignition engine under different injection conditions