Abstract:Supercritical CO2 can be used as a heat transfer fluid in a solar receiver, especially for a concentrating solar thermal power tower system. Such applications require better understanding of the heat transfer characteristics of supercritical CO2 in the solar receiver tube in a high temperature region. However, most of the existing experimental and numerical studies of the heat transfer characteristics of supercritical CO2 in tubes near the critical temperature region, and the corresponding heat transfer characteristics in the high temperature region are conducted. In this paper, a three-dimensional steady-state numerical simulation with the standard k-ε turbulent model is established by using ANSYS FLUENT for the flow and heat transfer of supercritical CO2 in a heated circular tube with an inner diameter of 6 mm and a length of 500 mm in the high temperature region. The effects of the fluid temperature (823–1023 K), the flow direction (horizontal, downward and upward), the pressure (7.5–9 MPa), the mass flux (200–500 kg·m–2·s–1) and the heat flux (100–800 kW·m–2) on the convection heat transfer coefficient and Nusselt number are discussed. The results show that the convection heat transfer coefficient increases while Nusselt number decreases nearly linearly with fluid temperature increasing. Both fluid direction and pressure have negligible effects on the convection heat transfer coefficient and Nusselt number. Moreover, the convective heat transfer coefficient and Nusselt number are enhanced greatly with the increasing of mass flux and the decreasing of heat flux, which is more obvious at a higher heat flux. The influences of buoyancy and flow acceleration on the heat transfer characteristics are also investigated. The buoyancy effect can be ignored within the present parameter range. However, the flow acceleration induced by the high heat flux significantly deteriorates the heat transfer preformation. Moreover, eight heat transfer correlations of supercritical fluid in tubes are evaluated and compared with the present numerical data. The comparison indicates that the correlations based on the thermal property modification show better performance in the heat transfer prediction in the high temperature region than those based on the dimensionless number modification. And Nusselt number predicted by the best correlation has a mean absolute relative deviation of 8.1% compared with the present numerical results, with all predicted data points located in the deviation bandwidth of ±20%. The present work can provide a theoretical guidance for the optimal design and safe operation of concentrating solar receivers where supercritical CO2 is used as a heat transfer fluid.

Effect of Heat Storage of Graphite on Flow Boiling Heat Transfer Characteristics in Solar Receiver

Thermal Characteristics of Grid Flat-Plate Heat Receiver in a Solar Power-Tower System

A STUDY ON BOILING HEAT TRANSFER OF SOLAR CAVITY RECEIVER

Effect of receiver diameter ratio on thermal performance of natural circulation steam generation system as applied to parabolic trough collector using water as working fluid

Thermal performance and thermal stress analysis of a supercritical CO2 solar conical receiver under different flow directions

Experimental studies on the flow and wall temperature distribution of solar cavity receiver under non-uniform heat flux

Visualized Investigation of the Onset of Flow Boiling Dynamic Instabilities in a Horizontal Arranged Tube under a High-Temperature Thermal Storage Boundary Condition

Study on Heat Transfer and Stress Characteristics of the Pressurized Volumetric Receiver in Solar Power Tower System

Study on the convective heat transfer characteristics of supercritical CO 2 in mini-channels under unilateral heating conditions for application in a compact solar receiver

Experimental investigation on thermal characteristics of a novel mesh flat-plate heat receiver in a solar power tower system

EXPERIMENTAL AND SIMULATION INVESTIGATION ON A PARABOLIC TROUGH SOLAR COLLECTOR

Improving Thermal Energy Storage in Solar Collectors: A Study of Aluminum Oxide Nanoparticles and Flow Rate Optimization

Convective heat transfer characteristics of supercritical CO 2 in mini-channels of compact solar receivers under unilateral heating conditions

Numerical Investigation on Porous Media Heat Transfer in A Solar Tower Receiver

Analysis on the Effects of Different Receiver Structures and Porous Parameters on the Volumetric Effects and Heat Transfer Performance of Porous Volumetric Solar Receiver

Numerical Investigation on Heat Transfer of Supercritical CO2 in Solar Receiver Tube in High Temperature Region

Numerical investigation on heat transfer and thermoelastic stress in a solar cavity receiver

Mechanical and Thermal Properties of Cement Composite Graphite for Solar Thermal Storage Materials

Thermal-fluid-mechanical analysis of tubular solar receiver panels using supercritical CO2 as heat transfer fluid under non-uniform solar flux distribution

Experimental Study on a Coiled Tube Solar Receiver under Variable Solar Radiation Condition

Research on effects of foam filling types on heat transfer of supercritical CO2 flow in tube