Abstract:The double skin facades are applied to multistory office building gradually as people require energy saving and ecotype. For the building with double skin facades, there are three surfaces subjected to wind pressure due to the airflow between the double facades: those are the outside and inside surfaces of the external skin facade and the outside surface of the internal skin facade. Consequently, the wind loads acting on the double skin facades become complicated and can not be obtained from code. In this paper, wind tunnel tests on a double skin facade building in Hangzhou were carried out to study the wind pressure distribution on each surface of the double skin facades. Furthermore, the characteristic of the wind pressure distribution on the long span canopy was also obtained from the tests. When wind is blowing from the side of canopy, the wind load acting on the upper and lower surfaces of the canopy is almost the same as that of the ordinary roof canopy. When wind load is blowing in front of the canopy, positive pressure will appear on the upper surface of the canopy. The structural shape factors of wind load for the building with large length width ratio are compared with those from the Loading Code for Building Structures (GB 50009—2001) for square building. It was found when the wind is blowing along the length of the rectangular building, the shape coefficients given for the square building in the code can also be used in designing rectangular building; while the wind is blowing along the width of the rectangular building,the negative pressure on both sides of the building as well as on the leeward side of the building will be much more larger than those of the square building.

Wind Load on Complicated-Shape Tall Building under Single Building and Double-Tower Conditions

NUMERICAL WIND TUNNEL TECHNIQUE FOR THE WIND RESISTANCE ANALYSIS OF LONG SPAN SPATIAL STRUCTURES

NUMERICAL SIMULATION OF WIND LOADS AND WIND FLOW FIELD AROUND A SPHERICAL TALL BUILDING

Wind Tunnel Experimental Study of Wind Pressure Distribution on Tall Buildings Considering Surrounding Interference

Distribution of wind load on symmetrical double- tower tall building

Numerical study on interference effects of wind loads about a cluster of tall buildings

Analysis and Practical Determination of Wind-Load Shape Factors for Low-Rise Hip Roofed Buildings

Analysis of Wind Vibration Characteristics of a Narrow-shaped Steel Residential High-rise Building

NUMERICAL SIMULATION OF WIND PRESSURES AND WIND ENVIRONMENT AROUND A COMPLEX-SHAPED HIGH-RISE BUILDING

NUMERICAL SIMULATION AND ANALYSIS OF WIND ENVIRONMENT AROUND BUILDING COMPLEX

Field Measurement of Wind Pressure on a Large-Scale Spatial Structure and Comparison with Wind Tunnel Test Results

Three‐dimensional Wind Load Effects and Wind‐induced Dynamic Responses of a Tall Building with X‐shape

Experimental investigation of Xiao Shan International Trade Centre in wind tunnel

Research of wind loads on S-type high-rise building with temperature joint in the middle part

Research on Interference of Wind Load on Complicated-Structured Buildings

Wind Tunnel Test Study on Wind Pressure Distribution on Double-Skin Facades of High-Rise Buildings with Typical Shapes

Wind Tunnel Test Study on Wind Load Characteristics for Double-Skin Facade Building with Rectangular Shape

3-D wind load and wind-induced response of X-shaped tall building

Calculation of Wind-Induced Responses and Equivalent Static Wind Loads of High-Rise Buildings Based on Wind Tunnel Tests

Effects of Attached Afterbody Shapes on Wind Forces on Rectangular Tall Buildings

Wind Environment Evaluation for Tall Building Complexes with Various Plan Arrangement