Secondary Development on Constitutive Model of Concrete and Steel for Beam Element in ABAQUS

Hao ZHANG,Guangwei CAO,Hongnan LI,Debin WANG,Min LI

DOI: https://doi.org/10.11717/j.issn:2095-1922.2018.04.09

2018-01-01

Abstract:To study the constitutive model of reinforced concrete material for ABAQUS fiber beam, and solve the problems that the lack of confined concrete constitutive model applied to three-dimensional (3 D) beam element in ABAQUS and that the owned metal constitutive model in ABAQUS cannot consider the effect of stiffness degradation, based on the classical uniaxial constitutive models of concrete and reinforcing steel, a VUMAT subroutine, involved the behavior of concrete damage plasticity and two kinds cyclic loading constitutive models of reinforcing steel, was compiled by FORTRAN. Firstly, the validity of subroutine was preliminary verified by means of the numerical simulation about a tension and compression test for reinforcing steel and plain concrete column; secondly, the numerical simulations for unidirectional quasi-static loading test of reinforced concrete (RC) column and beam were conducted, and the simulation results have a good agreement with experimental results, and relative errors are less than 4％. it is shown that the subroutine can simulate the hysteretic performance of RC members well, Meanwhile, comparing with the calculated results by the owned steel constitutive model in ABAQUS, the results showthat the selection of reinforcing hysteretic constitutive model has no obvious effect on the skeleton curve.However, the behavior of hysteresis is significantly changed. Finally, the dynamic elastic-plastic time-history analysis for a 12 storey concrete filled steel tube (CFST) frame structure was conducted, and the simulated resulted is also satisfactory. So it is shown that the developed subroutine is available to apply to the non-linear analysis of structures under dynamic loadings.