Abstract:Using the recently developed single shear specimen, deformation behavior of 304 austenitic stainless steel is studied systematically over a wide range of strain rates, covering quasi-static (0.001-0.1 s−1), medium (1-10 s−1), high (3000-6000 s−1) and very high (13000-39000 s−1) regimes, and temperatures between 77 and 1073 K were considered. The experimental flow stress curves show that: (1) the flow stress increases slightly at strain rates below 6000 s−1; concerning strain rates above 13000 s−1, however, an obvious flow stress upturn exists; (2) dynamic strain aging (DSA) occurs within the temperature range of 673 to 873 K and strain rates lower than 10 s−1; (3) both temperature sensitivity and strain rate sensitivity of the material are affected by DSA, and bell-shaped sensitivity curves form; (4) with increasing strain rates, peaks of the bell-shaped temperature sensitivity curves move to higher temperature regimes, and the evolution law is equally valid for the influence of temperature on the strain rate sensitivity curves. According to experiments, eight constitutive relations, including three phenomenological, four physical-based, and an artificial neural network, are established, including viscous drag effect at very high strain rates but excluding DSA phenomenon. Prediction capacities of the established constitutive models are checked by testing condition jump tests at randomly chosen strain rates and temperatures. Description capacities of the constitutive models in terms of strain hardening rate, temperature sensitivity and strain rate sensitivity are also analyzed.

Influence Of Pre-Strain On Mechanical Behavior Of Austenitic Stainless Steel And Construction Of Constitutive Models

The Effect of Pre-Strain on Tensile Behaviour of 316L Austenitic Stainless Steel

Microstructures-based Constitutive Analysis for Mechanical Properties of Gradient-Nanostructured 304 Stainless Steels

Mechanical Properties of Pre-Strained Austenitic Stainless Steel from the View of Energy Density

Revealing the Role of Pre-Strain on the Microstructure and Mechanical Properties of a High-Mn Austenitic Steel

Quantitative analysis of strength and plasticity of a 304 stainless steel based on the stress-strain curve

Mechanical Behavior Of 316l Stainless Steel After Strain Hardening

Effects of Strain Rate and Plastic Work on Martensitic Transformation Kinetics of Austenitic Stainless Steel 304

Influence of tensile strain rates on mechanical properties of 304 austenitic stainless steel at room temperature

A Model for Strain-Induced Martensitic Transformation of Trip Steel with Pre-Strain

Estimation of mechanical strength for pre-strained 316L austenitic stainless steel by small punch test

Material Enhancement Model for Austenitic Stainless Steel Sheets Subjected to Pre-stretching

Modeling the Tensile Strain Hardening Behavior of a Metastable AISI 301LN Austenitic Stainless Steel Pre-strained in Compression

Thermo-viscoplastic behavior and constitutive relations for 304 austenitic stainless steel over a wide range of strain rates covering quasi-static, medium, high and very high regimes

Influence of Uniaxial Tensile Pre-Strain on Forming Limit Curve by Using Biaxial Tensile Test

Influence of Strain Rate on Tensile Characteristics of Sus304 Metastable Austenitic Stainless Steel

Influence of Pre-Straining and Heating on Strain-Rate Sensitivity of AA5182-O

Strain-rate effect and constitutive models for S31803 duplex stainless steel

Temperature-Dependent SRS Behavior of 316L and Its Constitutive Model

Effects Of Strain And Strain-Induced Alpha '-Martensite On Passive Films In Aisi 304 Austenitic Stainless Steel

Effect Of Strain Rate On The Deformation-Induced Martensite Transformation And Mechanical Behavior Of Austenitic Stainless Steels For Cold Stretched Pressure Vessels