Abstract:Spray forming is an advanced technology that is used to produce a variety of high-performance materials with the characteristics of rapid solidification. By properly controlling of spray forming parameters, it is possible to fabricate near-net-shaped preforms, such as rod-billets, strips, and tubes. During the billet spray forming process, the shape of deposit strongly influences the solidification and consequently end-product quality. Therefore, it is necessary to reveal the shape forming mechanism in spray forming process. In the present work, a three-dimensional (3D) model, tracing the coordinates of the moving surface of a growing spray-formed billet, has been formulated to predict the shape evolution of the general deposit. This geometric model takes into account geometrical process parameters in the whole spray forming process: mass flux and mass distribution, position of the atomizer, distance between atomizer and the preform, substrate withdrawal velocity and rotation speed. This makes it possible to model not only the growth of a Gaussian shaped deposit in which case the spray axis and the rotation axis coincide, but also the profile evolution as there is a spray angle between these two axes. For this purpose, "shadowing effect" must be taken into account as a core part of the surface evolution algorithm. On the basis of this 3D model, a timesaving and accurate methodology is established to determine the shadowing effect coefficient, using the "triangular element checking" algorithm coupled with back face culling (BFC). The transient shape modeling has been validated by numerical algorithms and experimental investigation, and has proved that the simulated billet profiles are in good agreement with the experimental data. The effect of spray forming parameters, such as spray distribution parameters, withdrawal velocity, initial eccentric distance, spray angle and angular velocity of rotation, are analyzed. According to the obtained simulation results, the most dominant parameters affecting the shape evolution of deposit are the spray distribution parameters, withdrawal velocity, and initial eccentric distance. It is also found that the spray angle mainly affects the profile of the top transition region of the rod. The effect of the angular velocities of substrate on the shape evolution of the deposit is not significant. Finally, the maximum withdrawal velocity and maximum initial eccentric distance are deduced based on the analysis of shape form mechanism, which can be used to guide the process optimization during spray forming.

Neural Network Modeling and Simulation of Characteristic Dimension of Spray Deposited Preform

Three-Dimensional Mathematical Shape Model and Process Research of Spray-Formed Billet

Dynamic Modeling of Micro- and Nano-Sized Particles Impinging on the Substrate During Suspension Plasma Spraying

Modeling of Micro- and Nanoparticle Characteristics in DC Suspension Plasma Spray

Integral Numerical Modeling of the Deposition Profile of a Cold Spraying Process As an Additive Manufacturing Technology

Modeling and Simulation of Porosity in Spray Deposition

Modeling of the Shape Forming of Composite Roll

Nanoparticles Modeling in Axially Injection Suspension Plasma Spray of Zirconia and Alumina Ceramics

Prediction of In-Flight Particle Properties and Mechanical Performances of HVOF-Sprayed NiCr-Cr3C2 Coatings Based on a Hierarchical Neural Network

Image sensing and intelligent control of deposit dimensions in spray forming

Shape-predicted model of spray forming rod under scanning atomization

Investigation of Constitutive Model of As-Extruded Spray-Forming 7055 Aluminum Alloy Based on BP Artificial Neural Network

Film thickness distribution model with variable parameters for air spray gun

Modeling of Melt-flow-length During Injection Filling Stage Based on Dynamic Neural Network Soft-sensor

Modeling and optimizing software of spray deposition process

Prediction of deformation characteristics and critical velocities during cold-spray: A new 3D model

Shape modeling of spray formed columnar billets

Numerical simulation of nanoparticle pattern fabricated by electrostatic spray deposition

Improving the Generalization Ability of an Artificial Neural Network in Predicting In-Flight Particle Characteristics of an Atmospheric Plasma Spray Process

Research Progress on Numerical Simulation of the Deposition and Deformation Behavior of Cold Spray Particles

Analysis of Critical Velocity of Cold Spray Based on Machine Learning Method with Feature Selection