Abstract:3D-printed carbon fiber composites hold significant potential in aerospace applications because of their lightweight, high strength and complex structure fabrication capabilities. However, additive manufacturing characteristics such as high porosity, anisotropy and continuous fiber content significantly affect the mechanical properties of printed parts. The aim of this study is to investigate the influence of hybrid printing of short and continuous carbon fibers on the mechanical properties and failure mechanisms of composites and to develop a model to predict elastic properties considering porosity. First, mechanical testing and characterization of short and continuous fiber reinforced polyamide (nylon) print filaments are performed. The results indicate that the elastic modulus and ultimate strength of continuous carbon fiber filaments reach 60 GPa and 1500 MPa, respectively, while the strength and elastic modulus of short carbon fiber filaments reach 60 MPa and 1 GPa, respectively. Then tensile specimens with different continuous fiber orientations and different continuous fiber placement sequences are printed and tested using a multi-material 3D printing technique. The specimens are characterized before and after testing using scanning electron microscopy and microscopy to assess the porosity and failure mechanisms of specimens with different configurations. The results show that the mechanical properties of the printed parts are much lower than those of the print filaments, which proves the serious negative impact of the material extrusion process on the mechanical properties of the printed structural parts. Finally, an analytical method for predicting the elastic behavior of printed composites is developed by introducing the porosity factor in the volume-averaged stiffness model. For continuous and short fiber filled composites with different fiber contents and printing orientations, the predicted results are in agreement with the experiments, and the prediction error is greatly reduced from 30% to less than 5%.

Experimental and theoretical study on elastic modulus of oriented carbon fiber reinforced nylon 6 composites

Numerical prediction of effect of filling flow on short fiber orientation in injection molding

Fiber Orientation and Strain Rate-Dependent Tensile and Compressive Behavior of Injection Molded Polyamide-6 Reinforced with 20% Short Carbon Fiber

Experimental and Theoretical Studies on 3D Printed Short and Continuous Carbon Fiber Hybrid Reinforced Composites

A model to describe the cyclic anisotropic mechanical behavior of short fiber-reinforced thermoplastics

Properties of oriented carbon fiber/polyamide 12 composite parts fabricated by fused deposition modeling

Prediction for the mechanical property of short fiber-reinforced polymer composites through process modeling method

Correlation of rheology–orientation–tensile property in isotactic polypropylene/organoclay nanocomposites

Investigations of three-dimensional fiber orientation on mechanical impact behavior of short glass-fiber-reinforced PEEK composites

Additive manufacturing of short carbon filled fiber nylon: effect of build orientation on surface roughness and viscoelastic behavior

Characterization and prediction of tensile properties of carbon fiber-reinforced thermoplastics composed of hybrid short carbon fiber/PA6 fiber nonwoven mats

Process-structure-property analysis of short carbon fiber reinforced polymer composite via fused filament fabrication

Effect of fiber orientation and fiber volume fraction on the mechanical properties of all‐polyamide composites

Experimental and numerical study of the effects of fiber orientation on stress concentration of CFRE

Anisotropic mechanical properties of oriented carbon fiber filled polymer composites produced with fused filament fabrication

Exploring the influence of specimen types on the intralaminar fracture behavior of fiber-reinforced polymer matrix composites

Effect of fiber content and fiber orientation on mechanical behavior of fused filament fabricated continuous-glass-fiber-reinforced nylon

Prediction Models of Mechanical Properties of Jute/PLA Composite Based on X-ray Computed Tomography

STUDY ON THE MECHANICAL PROPERTIES OF CARBON FIBER REINFORCED CASTING NYLON

Experimental investigation and modeling study of the fiber orientation behavior

Parametric theoretical prediction of elastic properties and strength of fine weave pierced C/C composites