Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Adaptive estimation and simulation on the vibration frequency of missile system

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

A Fast Vibration-Level Adjustment Method for Low-Frequency Vibration Calibration Based on Modified Filtered-X Least Mean Square Algorithm

An Adaptive Feedback Vibration Control Algorithm

Design and Simulation of Adaptive Structure Filter for Missiles

An Enhanced Adaptive Notch Filtering Method for Online Multi-Frequency Estimation from Contaminated Signals of a Mechanical Control System

Multi-frequency Compensation for Active Magnetic Bearing-Flexible Rotor System Based on Adaptive Least Mean Square Algorithm with a Phase Shift

Inertial components filtering of laser beam riding missile aided by guidance and control information

Adaptive vibration control of a time-varying me- chanical system

An Estimation Approach Based on Predictive Filtering to Missile Guidance

Multi-Harmonic Adaptive Notch Filter based on Double Input

Multi-Missile Information Fusion Based on Virtual Measurement Kalman Filter

Adaptive Notch Filter Based Algorithm For Direct Complex Frequency Estimation

Simulation Research Of Active Vibration Control For Elastic Missile With Swing Nozzle Thrust Vector Control

Sufficient active control of uncertain low-frequency space micro-vibrations near measurement limit of acceleration sensors

Simulation Study of Fuzzy Adaptive Cascaded System Applied to the Test Table of Cold Launch

Signal Processing for Output Signals of the Inertia Sensors in the Missile Control System

A self-adaptive vibration pick-up method for vibrating wire sensor

Estimation of electrical signal frequency based on adaptive notch filter with variable step-size LMS algorithm

Robust Adaptive Control of Hypersonic Flight Vehicle with Aero-Servo-Elastic Effect.

Design and test of adaptive torsional vibration suppression method for helicopter power system with variable rotor speed