Calculation and comparative analysis of helical gear tooth contact dynamic stress

Hai-tao JIA,Feng WANG,Zong-de FANG

DOI: https://doi.org/10.13465/j.cnki.jvs.2014.22.030

2014-01-01

Abstract:In order to effectively calculate the helical gear tooth surface contact stress under dynamic conditions,a 6-DOF helical gear pair meshing type bending-torsion-axis coupling vibration model was established by considering time-varying mesh stiffness excitation and meshing impact excitation with rolling bearings supported.With this model,the meshing dynamic load was calculated.The helical gear tooth contact dynamic stress calculation method was put forward considering the meshing dynamic load,tooth surface load distribution,and Hertz contact theory.The dynamic stress of tooth contact was analyzed with Abaqus finite element analysis software.Dynamic contact stresses under three load torques of 800 N·m,1200 N·m and 1600 N·m were calculated.The results showed that the maximum contact stress obtained with the loaded tooth contact analysis method and that with AGMA standard method have the maximum difference of 11. 6%;the maximum difference between the maximum contact stress obtained with Abaqus finite element method and that with AGMA standard is 13.8%,the maximum deviation between the two tooth contact dynamic stress curves obtained with the two methods is 11.3%;all these facts verify the reasonableness and effectiveness of the proposed method.