Abstract:Recently, deepwater resource exploration has grown rapidly. Because the conditions of marine environment and seabed geology are more complex, deepwater drilling needs to numerous confront challenges, such as more complicated wellbore situations, low drilling efficiency, and high cost. Advanced novel drilling methods serve as significant impetus to facilitate the rapid advancement in deepwater oil-and-gas exploration and development. However, adopting riserless drilling methods may pollute marine environment and yield poor wall protective effects, while drilling methods with risers may suffer from relatively high cost and risk. Based on these dilemmas, in this study, a novel deepwater closed-cycle riserless drilling method with a subsea pump + gas combined lift is proposed. The proposed novel closed-cycle method has also established a multiphase flow drilling model and analyzed the effects of drilling fluid displacement, gas injection displacement, gas injection site and seawater depth on the multiphase flow in the wellbore. The simulation results revealed the following: As the gas migrates upward along the pipeline, its flow velocity first increases slowly and then rapidly owing to the volume expansion of gas. Larger displacement of drilling fluid demands greater working power of the subsea lifting pump, which is characterized by a nonlinear relationship. The gas injection displacement can effectively mitigate the load-bearing capacity of the pump, and increasing gas injection displacement leads to a decreased subsea lifting pump working power requirement; the decreasing effect on pump power load is more significant in the case of low gas injection displacement. Increasing the depth of gas injection sites reduces the subsea pump working with a decreasing slope with respect to the power descent. Finally, the subsea pump lifting power demand increases approximately linearly with an increasing seawater depth. Subsequently, an optimization method of hydraulic parameters for deepwater closed-cycle riserless drilling was proposed, which provides a theoretical foundation for the selection of subsea pumping power as well as the optimization of gas injection sites and displacement.

Error analysis of ADCP velocity measurement caused by riser vibration

Error Analysis and Correction of ADCP Attitude Dynamics under Platform Swing Conditions

An ADCP Attitude Dynamic Errors Correction Method Based on Angular Velocity Tensor and Radius Vector Estimation

Drilling Riser Design and Analysis for Deepwater Applications

Dynamic Analysis of A Deepwater Drilling Riser with A New Hang-off System

Dynamics Analysis of Marine Riser Using Different Approaches

Vortex-induced vibration characteristics of mining riser under the coupling effect of external ocean current and internal multiphase flow

Influence of the Heave Motion of a Floating Drilling Platform on the Crossflow Vortex-Induced Vibration of the Deepwater Drilling Riser

Time Domain Analysis Approach for Riser Vortex-Induced Vibration Based on Forced Vibration Test Data

Steel Catenary Riser Dynamic Analysis for Deepwater Applications in South China Sea

Damage Localization of Marine Risers Using Time Series of Vibration Signals

Dynamic characteristic analysis of riser considering drilling pipe contact collision

Experimental investigation of dynamic response and fatigue damage characteristics of free-hang risers under vessel motion

Analysis on Lateral Motion Response of Deep-Sea Mining Riser

FEM Analysis of Deepwater Drilling Risers under the Operability and Hang-off Working Conditions

Numerical Analysis of Dynamic and Fatigue Characteristics of Deep-Sea Mining Riser Considering Irregular Waves and Currents

An effective method to predict the motion of DDMS platform with Steel Catenary Riser

Simulation and Analysis of Multiphase Flow in a Novel Deepwater Closed-Cycle Riserless Drilling Method With a Subsea pump+gas Combined Lift

Mechanical analysis for deepwater drilling riser system with structural parameters uncertainty

Development of Dynamics Model of Seafloor Mining System and Analysis of Influence Factors in the Deploying Process

Fatigue damage assessment methodology for a deepwater subsea wellhead based on monitoring data