Abstract:Cyclic loading behavior, such as cyclic bending, is unavoidably involved in various forming processes and the service of end products. Understanding the mechanical behavior of magnesium (Mg) alloys under cyclic bending is essential for promoting their application. Despite existing research, the microscopic mechanisms at play during cyclic bending, specifically the slip and twinning-de-twinning (TDT), warrant further exploration, which is the innovative focus of our study. To address this need, cyclic bending tests were performed on an extruded AZ31 Mg plate with the in-situ digital-image-correlation (DIC) technology. And the texture evolution was determined through electro backscattered diffraction (EBSD) measurements. Concurrently, the crystal-plasticity-based bending-specific approach, EVPSC-BEND, incorporating the TDT scheme, is utilized to interpret the mechanisms involved in cyclic bending. The impact at the macroscopic level is manifested in asymmetric cyclic moment-curvature curves, stress-strain distribution, and shifting of the neutral layer. The developed textures at different regions of the beam and the twin volume fraction distribution further directly illustrate twinning-de-twinning behaviors. Particularly, the upper and lower halves of the beam experience very distinct cyclic behaviors simultaneously. The upper half experiences a twinning, detwinning, and twinning cycle, while the lower half experiences a twin-free, twinning, and detwinning cycle. Additionally, through modeling the cyclic bending with different initial textures, the strong texture dependence has been revealed. The behaviors of magnesium alloy beam under cyclic bending discovered in this work can shed light on the application of Mg alloys, such as forming processes and service of end product.

Three dimensional magnesium alloy bent pipe produced by dynamic flow control extrusion

An extrusion−shear−expanding process for manufacturing AZ31 magnesium alloy tube

Preparation of AZ31 Magnesium Alloy Thin-Walled Tubes by a New Type of Compound Extrusion by Direct Extrusion and Multi-Pass Bending

Influence of extrusion method on the microstructure and mechanical properties of formed magnesium alloy tubes

Continuous Extrusion Forming Technology of Magnesium Alloy Thin-Walled Tubules

Experimental and numerical investigation into rectangular tube extrusion of high-strength magnesium alloy

Effect of Three-High Rotary Piercing Process on Microstructure, Texture and Mechanical Properties of Magnesium Alloy Seamless Tube

On the inhomogeneous deformation behavior of magnesium alloy beam subjected to bending

Process and Microstructure of Magnesium Alloy Tube Manufactured by Divided Flow Extrusion

Microstructure and bendabiltiy of AM60 and AZ61 magnesium alloy tubes

Mechanical responses and deformation mechanisms in the AZ31 magnesium alloy during cyclic bending

Microstructure and Mechanical Properties of AZ80 Magnesium Alloy Tube Fabricated by Hot Flow Forming

Deformation mechanisms in AZ31 magnesium alloy tube bending

Microstructural evolution and mechanical properties of AZ31 Mg alloy fabricated by a novel bifurcation-equal channel angular pressing

Integrated Physical and Numerical Simulations of Weld Seam Formation During Extrusion of Magnesium Alloy

Experimental Study on Rotary Draw Bending of Magnesium Alloy Extruded Tubes

In-situ investigation on the microstructure evolution and plasticity of two magnesium alloys during three-point bending

Enhanced plasticity of magnesium alloy micro-tubes for vascular stents by double extrusion with large plastic deformation

Research on Hot Extrusion and Cold Drawing for Micro-Tube of Magnesium Alloys

Asymmetric Extrusion Technology of Mg Alloy: A Review

Finite-Elements Modeling and Simulation of Electrically-Assisted Rotary-Draw Bending Process for 6063 Aluminum Alloy Micro-Tube