Remediation of Cr(Ⅵ) in Chromite Ore Processing Residue by Sodium Sulfite and Sodium Phosphate

Yunyi LI,Jingxuan FENG,Xiao HE,Yangsheng LIU,Qunhui WANG
DOI: https://doi.org/10.16058/j.issn.1005-0930.2017.02.003
2017-01-01
Abstract:Chromite ore processing residue (COPR) is one of the most hazardous residues.Batch experiments were conducted to evaluate the feasibility of the remediation of Cr(Ⅵ) in COPR by the reductant sodium sulfite (Na2SO3).Different reaction time and Na2SO3 dosages were investigated to evaluate the efficiency of Cr(Ⅵ) reduction.The results indicated that Na2SO3 could effectively remove Cr (Ⅵ) from COPR.When adding Na2SO3 at a dosage of 12 the stoichiometric requirement and maintaining the treatment time over 15 days,78% of total Cr in leachate was removed;further increases of Na2SO3 dosage and/or treatment time had little effect on the removal of total Cr in leachate.Afterwards,sodium phosphate (Na3PO4) was added to immobilize the Cr (Ⅲ)-containing compounds in COPR.When the molar ratio of Na3PO4 to Cr(Ⅲ) was 4∶1,the total Cr in leachate was 6.9mg/L,which was much lower than the limit concentration (≤ 15mg/L) in China Hazardous Waste Identification Criteria (GB 5085.3-2007).Moreover,crystalline CrPO4 · 6H2O was observed after Na3PO4 was added as an immobilizer.In addition,the two-step treatment (i.e.,Na2 SO3 and Na3 PO4 were sequentially added into the COPR) was more beneficial to remove Cr (Ⅵ) than the one-step treatment (i.e.,Na2 SO3 and Na3 PO4 were simultaneously added).
What problem does this paper attempt to address?