Abstract:Using granulated blast furnace slag (GGBS) as the volcanic ash material and fly ash (FA) as the supplementary material, the study was conducted to investigate the mix proportions of an alkali-activated solid waste cementitious material under the stimulating effect of alkali activator carbide slag (CS). This type of cementitious material could serve as a substitute for a portion of cement usage, contributing to resource conservation and mitigating environmental pollution caused by solid waste. This facilitates green and sustainable development. Firstly, an analysis of three raw materials was conducted, and the mix proportions were designed with reference to the CaO-Al 2 O 3 -SiO 2 system of Portland cement. Then 28 groups of specimens were prepared based on the designed mix proportions. The flowability and setting time of each group of specimens were tested. It was observed that an increase in the amount of CS and a decrease in the amount of GGBS resulted in decreased flowability and earlier setting times of the specimens. Additionally, FA exhibited a retarding effect on setting time. Compressive strength tests were conducted on these specimens, revealing that the optimal CS content ranged between 20 % and 40 %. Overall, FA had minimal impact on compressive strength, but it contributed to increased compressive strength in the specimens at later ages. Subsequently, microscopic characterization of the hydration products was performed using X-ray Diffraction (XRD), Fourier Transform Infrared (FTIR), Differential Thermal Analysis (DTA), Scanning Electron Microscope (SEM), and Energy Dispersive Spectrometer (EDS). The hydration products were identified as predominantly composed of calcium silicate hydrate. The quality and defects in the microstructure of gel products from various specimen formulations were compared to elucidate differences in macroscopic performance. Finally, the hydration process mechanism diagram of alkali-activated materials was presented to illustrate the stimulation and formation of gel products, primarily composed of C-S-H. This diagram revealed the principles behind the action of alkali-activated cementitious materials. The proposed design and testing methodology for the GGBS-FA-CS system in this study had certain reference significance for research in the direction of alkali-activated solid waste cementitious materials.

DEVELOPMENT OF CLINKER-FREE CEMENTITIOUS MATERIAL WITH BOTTOM ASHES OF SOLID WASTE

Activation and Toxicity of Slag-fly Ash-fluorgypsum Cementitious Material

Study on Mixing Cement-Waste By-Product to Stabilize Soft Marine Clay

Research on Sustainable Development of Fine-Grained Material Cement Slurry

Investigation Of Cfb Bottom Ash For Cement Active Admixture

Recycling of municipal solid waste incineration fly ash for ordinary Portland cement production: A real-scale test

The Impact of Fly Ash on the Properties of Cementitious Materials Based on Slag-Steel Slag-Gypsum Solid Waste

Mine Tailings and Bottom Ash from Waste Incineration as Alternative Fine Aggregates for Controlled Low-Strength Materials

Recycling of Municipal Solid Waste Incineration By-Product for Cement Composites Preparation

Study on the Alkali–Sulfur Co-Activation and Mechanical Properties of Low-Carbon Cementitious Composite Materials Based on Electrolytic Manganese Residue, Carbide Slag, and Granulated Blast-Furnace Slag

Characterization of controlled low-strength material obtained from dewatered sludge and refuse incineration bottom ash: mechanical and microstructural perspectives

Study on the preparation, performance, and mechanism for solid waste cementitious materials

Optimization of Controlled Low-Strength Material from Multi-Component Coal-Based Solid Waste

Assessment of Pb-slag, MSWI bottom ash and boiler and fly ash for using as a fine aggregate in cement mortar

Microstructure and macro properties of sustainable alkali-activated fly ash mortar with various construction waste fines as binder replacement up to 100%

Performance of New Non-Clinker Aluminum Dross Cement Curing Agent

Effect of Finely Ground Coal Bottom Ash as Replacement for Portland Cement on the Properties of Ordinary Concrete

NON CLINKER REFUSE BOTTOM ASH BINDING MATERIAL STABILIZED-MARINE SOIL'S ENGINEERING CHARACTERISTICS

Study on preparation and activation enhancement effect of cold bonded multi-solid waste wrap-shell lightweight aggregates (SWSLAs) with low cement content

An Lc3-Type Binder Produced with Marine Clay and Municipal Waste Incineration Fly Ash

Research on Disposal of Solid Waste Incineration Fly Ashes by Cement Rotary Kiln Co-Processing