Influence of Clay Stabilizer and Viscosity Reducer on the Demulsification of Heavy Oil Emulsion

Meirong LI,Li DING,Kai SUN,Hua ZONG,Zhigang YIN
DOI: https://doi.org/10.19346/j.cnki.1000-4092.2016.01.036
2016-01-01
Abstract:In order to study the influence mechanism of clay stabilizer and heavy oil viscosity reducer on the demulsification in the process of tertiary oil recovery,the influence of cationic clay stabilizer NT-1A and anionic and non-ionic compounded viscosity reducer JN-1A on the interfacial film strength of Birman crude oil and four components demulsification was studied by means of interface expansion rheometer.The effects of NT-1A and JN-1A on the structure and morphology of asphaltene aggregation were observed by AFM.The results showed that asphaltene in crude oil had a higher modulus expansion.NT-1A promoted the formation of cross-linked aggregates of asphaltene molecules by electrostatic attraction and the size of aggregates grew from 489 nm to 665 nm.As a result,the interfacial film strength enhanced,which made the dilational modulus of crude oil increase from 3.23 mN/m to 5.93 mN/m and the dehydration rate reduce from 77.27% to 7.80%.JN-1A had stronger ability on the oil-water interface adsorption and replaced the active ingredient in crude oil.It inhibited the aggregation of asphaltene molecules on oil-water interface and the size of aggregates dropped from 489 nm to 215 nm.As a result,the interfacial film strength decreased,which made the dilational modulus reduce from 3.23 mN/m to 1.68 mN/m and the dehydration rate increase from 77.27% to 87.50%.NT-1A and JN-1A had a significant impact on the demulsification of heavy oil crude by changing the dilational modulus of asphaltene.
What problem does this paper attempt to address?