Abstract:Overcoming the strength-plasticity trade-off in GPa-grade dual-phase steel while simultaneously enhancing both properties poses a significant challenge. In this study, we propose an innovative strategy to break this inherent dilemma by designing an alternately arranged ferrite and martensite lamellar microstructure with appreciable deformation coordination in dual-phase steel. Compared to traditional dual-phase steel (DP steel) with a block microstructure and the same phase components, the newly developed heterogeneous lamellar dual-phase steel (L-DP steel) prepared by a cyclic intercritical quenching process demonstrates a remarkable 90 % increase in uniform elongation (from 9.1 +/- 0.4 % in DP steel to 17.3 +/- 0.3 % in L-DP steel). The ultimate tensile strength increases slightly from 1002 +/- 10 MPa (DP steel) to 1034 +/- 11 MPa (L-DP steel). The lamellar martensite and lamellar ferrite with a certain hardness difference lead to high back stress during plastic deformation, thereby ensuring the ultra-high tensile strength of the L-DP steel. The improved ductility of the L-DP steel is primarily attributed to the appreciable coordinated deformation ability of the lamellar microstructure and the considerable plastic deformation ability of lamellar martensite. These two outstanding capabilities allow this unique microstructure to elongate continuously along the tensile direction, facilitating persistent work hardening without premature cracking. Furthermore, the heterogeneous hardening triggered by the mutual constraints of the lamellar microstructure during the plastic deformation also contributes additional work hardening to enhance the ductility. The design of lamellar microstructure under a cyclic intercritical quenching process presents an efficient and feasible pathway for producing GPa-grade dual-phase steel with considerable ductility.

Production Process and Properties of DP800 Dual Phase Steel

On the use of thermomechanical processing to enhance the strength-ductility-toughness balance of plain low-carbon steel

The CSP Process Development of the Press Hardening Steel

Medium-carbon dual-phase steels with spheroidized ferrite matrix

Effect of Different Heat Treatment Processes on Microstructures and Mechanical Properties of DP Steels

Effect of Annealing Process on Microstructure, Texture, and Mechanical Properties of a Fe-Si-Cr-Mo-C Deep Drawing Dual-Phase Steel

On the Simultaneous Improving of Strength and Elongation in Dual Phase Steels via Cold Rolling

Process Design and Prediction of Mechanical Properties of Dual Phase Steels with Prepositional Ultra Fast Cooling

Achieving High Strength and High Ductility of Dual-Phase Steel Via Alternating Lamellar Microstructure

Annealing Temperature-Dependent Microstructure, Mechanical, and Tribological Properties of Intercritically Heat-Treated Dual-Phase Steel

Simultaneous enhancement of strength and ductility in ferrite-martensite steel via increasing the martensite fraction

Understanding the damage initiation and growth mechanisms of two DP800 dual phase grades

Microstructure tailoring for property improvements of DP steel via cyclic intercritical annealing

Processing and characterization of high strength dual-phase steel by two-step intercritical heat treatment process

Effect of annealing temperature on microstructure and properties of a dual phase steel

Effects of cryogenic treatment on mechanical properties and crystal orientation of 0.25C-0.80Si-1.6Mn steel with extraordinary strength-toughness

Dependence of mechanical properties on the phase composition of intercritically annealed medium-Mn steel as the main competitor of high-strength DP steels

Effect of annealing temperature on microstructure and properties of 1100 MPa grade cold-rolled dual-phase steel

Research on Hot Stamping-Carbon Partition-Intercritical Annealing Process of Medium Manganese Steel

Effect of martensite morphology and volume fraction on strain hardening and fracture behavior of martensite–ferrite dual phase steel

Effect of Annealing Process on Flanging Formability of 590MPa Grade Galvannealing Dual Phase Steel