Abstract:Abstract The axial cyclone separator has simple structure, operates to reducing dust concentration in grain storehouses, and features low production cost, and convenient installation. Aiming to obtain the separation characteristics of an axial flow guide separator, the particle wall collision and the performance of multi-tubes were simulated with Fluent. The renormalization group (RNG) k − ε model was used to study the turbulent modeling and the user define function (UDF) was used to calculate the particle-wall collision. The simulation and experimental results were compared to verify the computation model. The results showed that the basic feature of the flow pattern remains stable and the separation efficiency of 800 kg/m 3 particles is higher than 2650 kg/m 3 particles when the inlet velocity increases from 2 to 5 m/s. When the inlet velocity was 5 m/s, the normal velocity restitution ratio had a significant effect on the efficiency, the separation efficiency of 167 μm particles changed from 76.74 to 97.93% and a smaller normal velocity restitution ratio had a higher the efficiency. In comparison, the efficiency remained unchanged when changing the tangential velocity restitution ratio. Furthermore, the effects of three target wall materials on the separation efficiency were investigated. And the simulated efficiency the of 296 μm particle of 2024 aluminum, 410 stainless steel and Ga1–4V titanium were 82.15, 79.52 and 77.53% respectively. Besides, effects of tube diameter on performances of cyclone separator were discussed and high intense collisions between particles and walls may occur in a small diameter of cyclone tube, causing deteriorated separation performance. Moreover, with the addition of the dust chamber, the efficiency of cyclone used in combination is slightly improved since the vortex in the exhaust pipe has been finely changed.

Further Studies on the Multicyclone Solid-air Seperating Technology

Study on Separation Performance of Tri-Cone Water Medium Cyclone Based on CFD

Cyclonic Separation Technology: Researches and Developments

Separation Performance of New Type of Multi-Stage Axial Cyclone Used As Demister in Power Plant Emission System

Experimental investigation on separation characteristics of axial cyclone separator

Numerical investigation of separation efficiency of the cyclone with supercritical fluid–solid flow

Research and Application Advances in Supersonic Swirling Separator

Experimental Investigation on the Separation Characteristics of the Novel Combined Separator

ICONE19-43328 PERFORMANCE ANALYSIS OF CYCLONE SEPARATOR AND ITS OPTIMIZATION

Numerical simulation of the particle-wall collision strength and swirling effect on the performance of the axial flow cyclone separator

Influence of Inlet Structure on Separation Efficiency of Cyclone Separators

Numerical study of gas-solid flow in a radial-inlet structure cyclone separator

Experimental study on the separation performance of a novel oil–gas cyclone separator

SUPERSONIC SWIRLING SEPARATORS

Monitoring the Hydrodynamics and Critical Variation of Separation Efficiency of Cyclone Separator Via Acoustic Emission Technique with Multiple Analysis Methods

Experiment for Partial Reflux Axial-Flow Cyclone Separator with Two-Stage Separation

Research and application of hydrocyclonic separation technology

Cyclone Separation in a Supercritical Water Circulating Fluidized Bed Reactor for Coal/biomass Gasification: Structural Design and Numerical Analysis

Experimental Research on Separation Performance for Square Cyclone Separator under Different Constructional Details

Design of Multi-Stage Contracted Inlet Duct for Cyclone Separators

Experimental and Numerical Investigation on the Separation of Hydrophilic Fine Particles Using Heterogeneous Condensation Preconditioning Technique in Gas Cyclones