Abstract:Numerical investigations of combined impingement and film cooling based on different turbulence models have been carried out and compared in the present study. The specific test case combines the complex flow physics of the jet impinging, turning and subsequent mixing with hot mainstream, which consists of jet shear layer separation, wall boundary layer transition, coolant jet detachment and reattachment. The turbulence models employed are the k  − standard, RNG, and realizable models, the k − standard, SST, and Transition SST models, and the t l k − k − model. Numerical tests have been performed at three representative blowing ratios from low to high for each turbulence model. The computed cooling effectiveness from  equation models tend to be underpredicted at low blowing ratio while numerical profiles of cooling effectiveness achieve considerable agreement with the measured experiment data at moderate and high blowing ratios. In addition, the computed results from  equation models reasonably match the measured data at low blowing ratio but cooling effectiveness are markedly underpredicted at moderate and high blowing ratios. In contrast, those results from the t l k − k − model agree fairly well with those of the experiment at various blowing ratios. Owing to the nature description of the pre-transitional streamwise fluctuations in the laminar kinetic energy, the solutions from t l k − k − model clearly reveal the complex flow physics in the combined impinging and film cooling in the confined region, where the jet shear layer separation, boundary layer transition, coolant detachment and reattachment co-exist. However, the large number of specified parameters in the t l k − k − model still needs to be further optimized to reach the enhanced agreement with experimental data and obtain extensive applications for combined cooling schemes.

Research of k-ε Model for Simulating the Heat Transfer of a Round Air Jet Impinging Vertically on Plane Surface

Simulation of vertical round turbulent jets in shallow water

AN EXTENDED K-Ε MODEL FOR NUMERICAL SIMULATION OF WIND FLOW AROUND BUILDINGS

Numerical Simulations of Flow Structure and Heat Transfer in a Central Jet Bubbling Fluidized Bed

Numerical Study on Heat Transfer of an Impinging Turbulent Plane Jet with Confined Wall.

Modelling Of Impinging Flow And Heat Transfer In A Confined Narrow Gap

Movement of Impingement Heat Transfer by A Single Circular Jet with A Confined Wall

Thin liquid film flow and heat transfer under spray impingement

Numerical Study of the Flow and Heat Transfer of a Rectangular-tube Turbulent Impinging Jet Flow

The effects of rough surfaces on heat transfer and flow structures for turbulent round jet impingement

Numerical Study on Flow and Heat Transfer Characteristics of 3D Turbulent Impinging Jets

CFD Prediction for Multi-Jet Impingement Heat Transfer

Numerical Prediction of Transitional Features of Turbulent Forced Gas Flows in Circular Tubes with Strong Heating

A developed transition simulation model for turbulent plane jet impingement heat transfer

Numerical Study on Stagnation Point Heat Transfer by Jet Impingement in A Confined Narrow Gap

NUMERICAL INVESTIGATION OF DIFFERENT TURBULENCE MODELS APPLIED IN COMBINED IMPINGEMENT AND FILM COOLING

Numerical Study of Flow and Heat Transfer of Impingement Cooling on Model of Turbine Blade Leading Edge

Numerical Simulation of Separated Flows over Slender Body at High-Angle-of-attack with K-Ε Model Comforming Realizability

Three-Dimensional Simulation of Turbulent Rectangular and Square Impinging Jet Flows

Prediction of heat transfer for a single round jet impingement using the GEKO turbulence model

Experimental Investigation of Local and Average Heat Transfer Coefficients under an Inline Impinging Jet Array, Including Jets with Low Impingement Distance and Inclined Angle