Effects Of Tool Path On Tribological Behavior Of High-Speed Ball Milled Surface Of Hardened Skd11 Steel

Huang Wei-Min,Zhao Jun,Ai Xing,Wang Da-Wei,Wang Gui-Jie

DOI: https://doi.org/10.11933/j.issn.1007-9289.20160803002

2017-01-01

China surface engineering

Abstract:Effects of cutting tool path on tribological behavior of high speed ball milled surfaces of hardened SKD11 steel was investigated through ring-on-block friction and wear tests with the help of white light interferometer, super-high magnification lens zoom 3D microscope and microhardness tester. The results show that tribological behavior of ball milled surface has direction tendency. A minimum friction coefficient and wear width is reached when the sliding direction is perpendicular to the tool path direction. However, a maximum friction coefficient and wear width is achieved when the intersection angle between siding direction and tool path direction is 45 degrees. Topography direction of ball milled surface is determined by the cutting tool path, which influences the contact stress and ability of trapping wear debris and then the ploughing and sticking effect. Main wear mechanism is dominated by abrasive wear and oxidative wear under dry sliding condition. In addition, micro-grooves induced by ball end milling process vanishes absolutely after sliding for 15 min. Nevertheless, micro-grooves are clearly observed though some abrasive wear characteristics are presented on the samples where the intersaction angle equaled to 0 degrees and 45 degrees. Samples obtained with the angle 90 degrees scarcely show any scratches, which indicat a good anti-attrition ability.