Abstract:AP1000 nuclear power main pipe, a type of complicated thick-walled tube structure with both high and thick-walled nozzles, is one of the key parts in nuclear island. It is required to be manufactured by integral plastic forming technique. Up to now, no economical and efficient plastic forming process for AP1000 main pipe has been reported. To aim for forming the tube structure with a nozzle such as AP1000 main pipe, a radial upset-extruding (RUE) process was developed, in which the initial billet is an extruded tube with a hole. RUE process is an extrusion method which realizes radial outflow of the metal around the hole of tube billet through an axial upsetting force and restriction of dies. Thick-walled tube structure with a nozzle derived from AP1000 main pipe was simplified to be a thick-walled three-way pipe, on which RUE process was analyzed based. Combined with reduced scale model experiments, thermomechanical coupled finite element analysis integrated with recrystallization models of 316LN was performed to investigate RUE process. Metal flow, deformation distribution, recrystallization distribution, and extrusion load and clamping load in RUE process was analyzed. The experimental workpiece of pure lead based on reduced scale model validate metal flow behavior predicted by using numerical simulation. The results indicate that the essence of RUE process is to deflect the flow of the material around the orifice of the tube billet. The loads of dies are significantly sensitive to the initial forming temperature and the friction coefficient, while the impact of the extrusion velocity is negligible. RUE process could be used to form thick-walled tube structure with a nozzle, and it has a potential for solving the manufacture of AP1000 main pipe.

Hot extrusion forming process of pipe with tail cushion

Microbulging Extrusion of Aluminum Alloy to Fabricate Micro/meso Features for Heat Pipes

Study on Centrifugal Compound Casting-hot Extrusion-Cold Rolling Process for Composite Pipe

Micro-extrusion process and microstructure evolution of miniature heat pipe in 6063 aluminum alloy

Numerical Study on Forming Complex Fitting Body on End of Integrated Stainless Steel Pipe Without Welds

Hot Radial Upset-Extruding Process for Tube Structure with a Nozzle of 316LN Stainless Steel

Continuous Extrusion Forming Technology of Magnesium Alloy Thin-Walled Tubules

Hot Deformation Behavior and Recrystallization Analysis of Pipe 20CrNiMo Steel

Extrusion forming simulation of microchannel flat tube and welding quality prediction

Optimization of Hot Backward Extrusion Process Parameters for Seamless Tube of Mg-8Gd-3Y Alloy by Finite Element Simulation

SIMULATION OF ALUMINUM FIXTURE PART HOT EXTRUSION PROCESS WITH THE FINITE VOLUME METHOD

Effect Of Die Design In Microchannel Tube Extrusion

Study on Warm and Cold Extrusion of Cup-shaped Part

Study on Extrusion of Aluminum Microchannel Flat Tube

FE Modeling of Warm Flanging Process of Large T-pipe from Thick-Wall Cylinder

Effects of Temperature Distribution on Microstructure and Mechanical Properties of Hot Extruded Al–Zn–Mg–Cu Alloy Pipe with Variable Cross-Section

Microstructure Development and Texture Evolution of Aluminum Multi-Port Extrusion Tube During the Porthole Die Extrusion

Die Design and Finite Element Analysis of Welding Seams during Aluminum Alloy Tube Extrusion

Metal Flow Hysteresis Behavior and Shape Control Strategy During Porthole Die Extrusion of Micro Heat Pipe

Study on forming process of equal wall thickness metal spiral pipe by single screw pump

Numerical Simulation and Experimental Confirmation of a Bimetallic Pipe Forming Process