Abstract:The accurate geometry and effective control during the ring rolling process are the prerequisites for the ring products’ precise forming. In this paper, the interaction modes and rules between ring and rolls in vertical hot ring rolling (VHRR) process are analyzed, and the change laws of the ring’s geometry are studied. Based on the ABAQUS/Explicit software and its subroutine VUAMP, the finite element (FE) model of the VHRR process with measurement and control is established. Then, the ring rolling process of a groove-section profile ring is simulated. During the simulation, the ring’s outer diameter, roundness error, and the stability of the rolling process are detected in time, and the close-loop control of feed plan of the drive roll and measuring roll are also employed. The results obtained show the following: (1) Four feed stages are divided by means of a step-down feed movement, that is, bite stage, main rolling stage, precise forming stage, and sizing stage. (2) At bite and main rolling stages of the VHRR process, the ring’s center swings in a spiral line, and the rolling process is unstable, the ring’s roundness becomes worse, while the process is entering the precise forming stage, by means of the guide roll, the rolling process becomes steady and the ring’s roundness tends to be better. (3) The measuring roll contacts with the ring at the main rolling stage, afterwards, it is pushed back at the precise forming stage by ring’s growth. When the measuring roll meets the desired displacement value, a stop feeding command will be fed back, and the ring rolling process enters the sizing stage. At the sizing stage, the ring’s outer diameter still increases a little. (4) A series of VHRR experiments are conducted, and FE results are in good agreement with experimental results. The absolute errors of the ring’s outer diameter and the roundness are within 1 mm. The research results of this paper have practical significance to guide the VHRR production.

Technology of rolling with single groove for GH4169 profiled section

Technology of rolling 40Cr cam with fixed groove

Study on Fixed Grooves Rolling Process for TC4 Titanium Alloy Angle Section Profiles

Production Practice of Rolling 8mm Thickness Plate by 4300mm Heavy Plate Mill

A study on simulation of deformation during roll-forging process using system of special shaped and hat groove

Numerical Simulation of Microstructure Evolution of Large GCr15 Bar During Multi-Pass Rough Rolling

FE simulation of multi-pass reversible hot rolling of GH4169 alloy plate

Process design and finite element analysis of multi-station two-roller cassette hot rolling for aluminum alloy 6061 wire

Theoretical Analysis and Numerical Simulation of External Spline Cold Rolling

A Novel Multipass Incremental Gear Rolling Process with Blank and Rolling Die Axes Crossed

A Hybrid of Theory and Numerical Simulation Research for Virtual Rolling of Double-Groove Ball Rings

Finite element analysis on axial-pushed incremental warm rolling process of spline shaft with 42CrMo steel and relevant improvement

Numerical simulation of void elimination in the billet during hot shape rolling processes based on the Gurson–Tvergaard–Needleman model

Numerical simulation and experimental study on geometry variations and process control method of vertical hot ring rolling

Finite element analysis on shape deformation of the macro‐structure region during hot‐rolling process for gear steel FAS3420H and its modification

Simulation of Multi-pass Hot Rolling Process of Direct-chilled AZ31B Magnesium Alloy

Modeling of Deep Rolling as a Distortion Compensation Strategy during Profile Grinding

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters

Relationship Between Hardness and Deformation During Cold Rolling Process of Complex Profiles

Experiments Study on the Rolling Process for Heavy Disk

Investigation on the Effects of Tooth Profile Deviation in Gear Rolling Process