Abstract:Automobile lightweight can effectively save fuel consumption and reduce CO, emissions. Aluminum and its alloys are desirable for the automotive industry due to their excellent high-strength to weight ratio. However, due to the introduction of the welding seam, it has brought new changes to the forming process, especially to the forming limit. To establish a reasonable forming limit curve (FLC) analysis method of friction stir welding (FSW) aluminum alloy blank, a new theoretical model was proposed based on the new second order function constitutive model. The main idea is using the differences in mechanical property between the welding and heat affected zone substitution for the hypothesis of geometry groove in the classic M-K theoretical model. The new second order function constitutive model was applied to M-K theoretical model. Eventually, a new FLC theoretical model for FSW aluminum alloy blank was established. Such theoretical model also overcomes the low strain hardening exponent of aluminum alloy material, which leads to a poor regression accuracy by power-exponent function model. The forming limit test for FSW aluminum alloy blank was performed, and the real-time strain was measured by three-dimensional digital speckle strain measurement system (XJTUDIC). Finally, the results of experiments and the theoretical analysis are compared. Compared with the traditional power law, the regression result of the new second order function constitutive model on the stress-strain curve no matter in the initial yield stage or in late deformation stage has a good fitting precision. The maximum fitting error of the power law on the stress-strain curve is more than 12%, but the fitting error of the new second order function constitutive model is less than 1%. The theoretical prediction based on the new second order function constitutive model is significantly better than the theoretical predictions based on power law in predicting the forming limit of FSW aluminum alloy blank. The prediction error of the first principal strain based on the new second order function constitutive model is less than 0.01. While the maximum prediction error of the first principal strain based on the power law is 0.14.

Formability Window of Aluminium Alloy Sheet at Variable Blank-Holder Force

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Control of the blank-holder force to improve the formability of aluminum alloy sheet

Evaluation of Fracture Limit in Automotive Aluminium Alloy Sheet Forming

Effect of variable blank-holder forces on the formability of aluminum alloy sheets during sheet metal forming

The Numerical Analysis of the Formability of Aluminium Alloy Sheet in Complex Shape Box Deep Drawing Forming

Application of New Vbhf Optimization Strategy to Improve Formability of Automobile Panels with Aluminum Alloy Sheet

A New Strategy to Optimize Variable Blank Holder Force Towards Improving the Forming Limits of Aluminum Sheet Metal Forming

Evaluation of forming limit in viscous pressure forming of automotive aluminum alloy 6k21-T4 sheet

Novel algorithm for determining optimal blankholder forces in deep drawing of aluminum alloy sheet

The High Strength Steel Formability Based on Blank-Holder Force Design

Experimental and numerical investigations into the ductile fracture during the forming of flat-rolled 5083-O aluminum alloy sheet

Modeling of constitutive behavior and ductile fracture of AA5A06 aluminum alloy sheet in warm hydroforming process

Forming Limit of FSW Aluminum Alloy Blank Based on a New Constitutive Model

Experimental and Numerical Investigation on Strengthening Behavior of 7075 Aluminum Alloy Sheets in Hot Forming–Quenching Integrated Process

Study on hydroforming of AA6061-T6 aluminum alloy sheet based on upper sheet

Multi-Objective Optimization of Process Parameters in 6016 Aluminum Alloy Hot Stamping Using Taguchi-Grey Relational Analysis

The Effect of Variable Blank-Holder Forces on Formability of Ractangle Box Deep Drawing

Numerical Simulation of Warm Deep Drawing of AZ31 Magnesium Alloy Sheet with Variable Blank Holder Force

Finite Element Modeling for Deep-Drawing of Aluminum Alloy Sheet 6014-T4 Using Anisotropic Yield and Non-Afr Models

Prediction of Forming Limit for Aluminum Alloy Sheet Coupling with Temperature and Strain Rate