Abstract:The Hazelett continuous casting and rolling process represents a leading-edge production method for cold-rolled aluminum sheet and strip billets in the world. Its solidification microstructure significantly influences the quality of billets produced for cold rolling of aluminum sheets and strips. In this study, employing the CAFE (Cellular Automaton—Finite Element) method, we developed a coupled computational model to simulate the solidification microstructure in the Hazelett continuous casting process. We investigated the impact of nucleation parameters, casting temperature, and continuous casting speed on the microstructural evolution of the continuous casting billet. Through integrated metallographic analyses, we aimed to elucidate the controlling mechanisms underlying the Hazelett continuous casting process and its resultant microstructure. The results demonstrate that the equiaxed rate of grains increases with an increase in nucleation density, and the grain size decreases under constant cooling strength. With other nucleation parameters held constant, the grain size decreases as undercooling increases, and the columnar crystal zone expands. The nucleation density of the Hazelett continuous casting aluminum alloy has been determined to range between 1011 m−3 and 1013 m−3, and the undercooling ranges between 1 °C and 2.5 °C. The solidified grain structure can be controlled between 35 μm and 72 μm. The grain size of the continuous casting billet increases with an increase in pouring temperature and decreases as the casting speed increases. Elevating the pouring temperature positively impacts the fraction of high-angle grain boundaries and promotes the dendritic to equiaxed grain transition. Moreover, there exists potential for further optimization of continuous casting process parameters.

Numerical Simulation of Solidification Structures of Ag-28Cu Alloy Continuous Casting Based on 3D-CAFE Method

Numerical Simulation of Temperature Field and Grain Structure in Cu-10Al Alloy Produced by Heated Mould Continuous Casting

Experimental and numerical studies on the influence of centrifugal casting parameters on the solidification structure of Al-Cu alloy

Simulation of microstructures in solidification of aluminum twin-roll casting based on CA

Numerical Simulation of Recalescence of 3-Dimensional Isothermal Solidification for Binary Alloy Using Phase-Field Approach

Simulation of the solidification organization of X15CrNiSi20-12 alloy castings during investment casting based on the CAFE model

Microstructure Simulation of Aluminum Alloy Casting Based on CA Method

Simulation and Study of Influencing Factors on the Solidification Microstructure of Hazelett Continuous Casting Slabs Using CAFE Model

Numerical Simulation of Solidification Process in an SCR Wheel and Belt Continuous Caster

Transient Modeling Of Grain Structure And Macrosegregation During Direct Chill Casting Of Al-Cu Alloy

Numerical Simulation And Optimization Of Directional Solidification Process Of Single Crystal Superalloy Casting

Simulation of Mg-Gd Alloy During Solidification Process

Numerical modeling and simulation of water cooling-controlled solidification for aluminum alloy investment casting

Mould Taper Optimization for Continuous Casting Steels by Numerical Simulation

Numerical Simulation on Fluid Flow, Heat and Mass Transfer in Solidification of Fe-C Alloys

Numerical Analysis for Position and Shape of Solid-Liquid Interface during Continuous Casting of Single Crystal Cu

Numerical Simulation of Influence of Vertical Continuous Casting Process Parameters on Heat Transfer and Mold Stress of C71500 Large Diameter Hollow Ingot

Numerical simulation of microstructure of aluminum alloy casting using macro-micro coupled method

Simulation of the as-cast structure of Al-4.0wt.%Cu ingots with a 5-phase mixed columnar-equiaxed solidification model

Simulation of Fine Grain Casting Process of Superalloy K4202 by Thermal Control Method

Modelling of Solidification Structure and Macro-Segregation in an Industrial DC Cast Slab