Abstract:Compliance control is required in the applications of robots for assembling, grinding, polishing and human-robot interface, which needs both position control and force control of robots. The impedance control based on joint torque servo is a promising and practical method to realize compliance control in industrial applications. The performance of a joint torque servo controller is thus crucial to the success of compliance control. However, both nonlinear friction torque of the joint motor and varied dynamics of environmental contact during manipulation increase control difficulty greatly. This paper focuses on the compliance control problem and presents a new joint torque servo controller which is a cascading structure including an inner velocity feedback loop and an outer torque control loop. Due to the high signal-to-noise ratio of the motor velocity, an extended state observer is designed to effectively estimate and compensate for the motor friction torque, varied dynamics of environmental contact and other unknown disturbance. And benefiting from the introduction of the efficient and powerful velocity inner loop, the new torque controller performs very well not only in the rigid but also elastic contact environment. Then a standard PD controller is designed in the outer torque loop to produce the control law. Based on the satisfactory joint torque controller, a simplified impedance control algorithm is designed to achieve the force control. Experiments with three other joint torque controllers on a robot manipulator are conducted to demonstrate the proposed joint torque method and the overall force control framework. These results show the proposed joint torque controller can reduce the steady-state error from 3.07 Nm to 0.21 Nm which indicates the joint actuator friction can be eliminated by more than 99%. And a substantial improvement can also be observed in the experiments of force control based on the new joint torque controller.

Research of the Direct Teaching of Industrial Robots Based on Active Compliance Control

Design and Realization of Embedded Robotics Teaching System

Intuitive Control System for Industrial Robot Application Using Smartphone

Soft Design of Embedded Robotics Teaching System

Liberating Humanity from Heavy Labor: Dual-Arm Coordination and Teleoperation Control for an Assistive Robot

Design of Direct Teaching Behavior of Collaborative Robot Based on Force Interaction

Interactive Control System of Variable Force Feedback Robot Based on Spring Model

A Sensorless Hand Guiding Scheme Based on Model Identification and Control for Industrial Robot

Compliant Human-Robot Object Transfer Based on Modular 3-Axis Force Sensor for Collaborative Manufacturing.

Learning Variable Compliance Control From a Few Demonstrations for Bimanual Robot with Haptic Feedback Teleoperation System

Compliance Control for Robot Manipulation in Contact with a Varied Environment Based on a New Joint Torque Controller

Learning compliant grasping and manipulation by teleoperation with adaptive force control

Deep reinforcement learning on variable stiffness compliant control for programming-free robotic assembly in smart manufacturing

Compliant Coordination Control of Two Moving Industrial Robots

A practical PID variable stiffness control and its enhancement for compliant force-tracking interactions with unknown environments

A Teaching Demonstration Set of a 5-DOF Robotic Arm Controlled by PLC

Adaptive PID control of multi-DOF industrial robot based on neural network

Design and implementation of control system for transport robot based on STM32 microcontroller

Adaptive Direct Teaching Control with Variable Load of the Lower Limb Rehabilitation Robot (LLR-II)

A systematic design procedure of force controllers for industrial robots

Synthesis Methods and Experiment Validation of Compliant Force Controller Based Inner Position Loop.