Abstract:This paper presents an experimental and theoretical study of surface generation in the ultra-precision grinding of hard and brittle materials. The study takes into account the material properties, the relative vibration between the grinding wheel and the workpiece, the machining parameters and the phase shift of the grinding process. The Taguchi approach is employed to study the influence of machining parameters on the surface quality and shows that the feed speed and rotational speed of the workpiece are key factors. Experiments have been conducted to study individual variables, and the results further show that the feed rate and the cross-feed distance have a significant effect on surface generation. It is found that the spirals around the central area of the workpiece are the primary mechanism for surface generation, which originates from the synchronous relative tool-work vibration. The integral part of the ratio of the rotational speed of the grinding wheel to rotational speed of the workpiece determines the number of spirals and its fractional part controls the spiral geometry. A theoretical model for predicting the single spiral generation has been developed to explain the accumulation of the phase shift and the geometry. The changeable feed speed near the end of grinding is also modelled, revealing the approximate straight lines around one circle in the central region. The simulated results indicate that the theoretical models and the ground surfaces are in close agreement. The scallop-height model is developed to calculate the influence of phase shift on surface quality, and it is found that the phase shift near the medium value can effectively improve surface quality. Finally, a comparison of different surface generation mechanisms in grinding mould steel, tungsten carbide (WC) and reaction bonded silicon carbide (RB-SiC) is made. It is interesting to note that the Spanzipfel effect contributes to the surface generation not only on ductile materials such as mould steel but also on brittle materials such as WC and RB-SiC. The Spanzipfel effect is the most significant in grinding mould steel. For WC and RB-SiC, the ground surface contains both a ductile region and a brittle region in the form of micro-fractures.

Research on New Centerless Grinding Technique and Its Application for Microscale Parts

New Ultrasonic Elliptic Vibration Centerless Grinding Technique

Research on the key technique for numerical control grinding arbitrary n-polygon shafts

A Micro-Feed Actuator for Ultra-Precision Grinding of Brittle Materials

Theoretical Generalization and Research on the Mechanism of the Unsteady-State Grinding Technique

Nano-Precision Synergistic Finishing Process Integrated ELID-Grinding and MRF

An Experimental Investigation on Ultrasonic Vibration-Assisted Grinding of Sio2f/Sio2 Composites

One-Point Nano-Grinding for Micro-Aspherical Glass Lens Mould

Creep Feed Surface Grinding NC Technology by Cup Wheel in Radome Machining

Design Method and Numerical Control Machining Principle for an Arbitrary N-Polygon Noncircular Section

Studies on the Surface Quality of the Unsteady-State Grinding Technique

A Study on the Influence of Central Edge Absence in Helical Grinding for Micro-Hole Fabrication

Euler’s equation grinding track, microgrinding mechanism, and process research of space optical crystal materials

Research on Geometric Constraint Strategies for Controlling the Diameter of Micro−Shafts Manufactured via Wire Electric Discharge Grinding

Investigation of inner-jet electrochemical face grinding of thin-walled rotational parts

An experimental and theoretical analysis of surface generation in the ultra-precision grinding of hard and brittle materials

Analysis and optimization of microchannel array precision grinding processes with micro-structured micro-grinding tool

Ultra-precision time-controlled grinding for flat mechanical parts with weak stiffness

Process Monitoring in Precision Cylindrical Traverse Grinding of Slender Bar Using Acoustic Emission Technology

Surface quality and cylindricity of ultrasonic elliptical vibration–assisted centerless grinding of micro-rod YAG single crystals

Development and performance of a novel ultrasonic vibration plate sonotrode for grinding