Research on Precise Damping Matching for Transient Electromagnetic Transmitter
BAO Minghui,ZHANG Minming,LI Bo,LI Junqiang,ZHOU Mi,FU Zhihong
DOI: https://doi.org/10.12783/dtcse/pcmm2018/23667
2020-01-01
Abstract:A method is introduced to precisely match the damping resistor of different transmitting coils via the output port of the transient electromagnetic transmitter. Theoretical analysis of the distributed parameter model of the transmitting coil are described. Equations calculating the critical damping resistor are derived from the self-inductance, internal resistance, and the distributed capacitance of the transmitting coil, accordingly. Extensive experiments demonstrate that the proposed method can rectify the overshoot and oscillation phenomenon of the emission current during the late period of the turn-off. Introduction Transient electromagnetic method (TEM) is a geophysical exploration method, which also known as time domain electromagnetic method [1]. Transient electromagnetic system consists of transmitter, receiver and data processing software. The principle of the system is transmitter sends a constant amplitude current pulse to ground periodically through ungrounded transmitting coil, which can create a primary pulse magnetic field under the ground. Then, primary pulse magnetic field can induce eddy current if there has a conductive medium under the ground. When turn off the pulse, receiving coil can receive the secondary magnetic field generated by the eddy current. The underground geological structure can be obtained after secondary magnetic field data analyzed and processed by data processing software [2-3]. The ideal emission current waveform send by transient electromagnetic transmitter is bipolarity constant amplitude rectangular wave [4]. In practice, however, emission current falling edge is exponentially because of the load is an inductor, which has self-inductance and parasitic capacitance. Therefore, the actual response is second order underdamped response, which can lead to overshoot and oscillation phenomenon of the emission current during the late period of the turn-off [5]. It will affect early signal of secondary magnetic field seriously. One method widely used to accelerate the emission current decrease and reduce oscillation, is to use a damped resistor in parallel with the coil to ensure system to be critical damping response, and the resistor value varies according to the coil parameters, and cooperating with the voltage stabilizing clamp technique for increasing the emission current falling edge slope [5]. Voltage Stabilizing Clamp Fast turn-off Principle Literature [5] pointed out that using voltage stabilizing clamp fast turn-off transmitting circuit, as shown in Figure 1, can adjust the emission current falling edge. In Figure 1, the dotted line frame 1 is clamp circuit, and the dotted line frame 2 is adjustable constant pressure source. When turn off the forward power supply, emission current 0( ) i t begins to drop, current forms a continuous loop through 240 load L, D7, C1 and D2. If the voltage value 1 C u remains constant during current turn-off, the emission current will decrease linearly, and the pace of decline is proportional to voltage value.