Abstract:In this study, the integrated three-in-one (temperature, humidity, and wind speed) microsensor was made through the technology of the Micro-electro-mechanical Systems (MEMS) to measure three important physical quantities of the internal environment of the cold air pipe of the Heating, Ventilation and Air Conditioning (HVAC) in the factory, plan the installation positions of the integrated three-in-one microsensor and commercially available wind speed sensor required by the internal environment of the cold air pipe, and conduct the actual 310-h long term test and comparison. In the experiment, it was also observed that the self-made micro wind speed sensor had higher stability compared to the commercially available wind speed sensor (FS7.0.1L.195). The self-made micro wind speed sensor has a variation range of ±200 mm/s, while the commercially available wind speed sensor a variation range of ±1000 mm/s. The commercially available wind speed sensor (FS7.0.1L.195) can only measure the wind speed; however, the self-made integrated three-in-one microsensor can conduct real-time measurements of temperature and humidity according to the environment at that time, and use different calibration curves to know the wind speed. As a result, it is more accurate and less costly than commercially available wind speed sensors. The material cost of self-made integrated three-in-one microsensor includes chemicals, equipment usage fees, and wires. In the future, factories may install a large number of self-made integrated three-in-one microsensors in place of commercially available wind speed sensors. Through real-time wireless measurements, the self-made integrated three-in-one microsensors can achieve the control optimization of the HVAC cold air pipe's internal environment to improve the quality of manufactured materials.

Design of Temperature and Humidity Integrative Sensor Used by Automobile

Design of temperature and humidity sensor for automobile climate controlling

Design of Temperature Testing System in Multi-Parameter Combined Environmental Test

Design of integrative sensor of 1-wire automobile solar and temperature-humidity

Temperature and Humidity Control for an Automobile During Heating Period

Design and Development on Temperature and Humidity Sensors Used in the Closed Hood of Paper Machines

Design and Implementation of a Low-Energy-Consumption Air-Conditioning Control System for Smart Vehicle

Performance Study of a Constant Temperature and Humidity Air-Conditioning System with Temperature and Humidity Independent Control Device

Optimum Control Strategy and Performance Simulation of a Constant Temperature and Humidity Air-conditioning System

Development of Constant Temperature & Humidity Air Condition System for Measurement and Testing

The Application of a Self-Made Integrated Three-in-One Microsensor and Commercially Available Wind Speed Sensor to the Cold Air Pipe of the Heating, Ventilation, and Air Conditioning in a Factory for Real-Time Wireless Measurement

Common Fault Diagnosis and Elimination of Automobile Air-Conditioning Refrigeration System: based on Smart Sensors

Design of Temperature Control System for Electronic Nose

Development of high precision multifunction apparatus for measuring temperature,humidity and oxygen concentration

Study and Development of Automatic Air Conditioning Controller for Cars

Fuzzy Logic Controlled Simulation in Regulating Thermal Comfort and Indoor Air Quality Using a Vehicle Heating, Ventilation, and Air-Conditioning System

Fuzzy-based thermal management control analysis of vehicle air conditioning system

Analysis of Inside Air Circulation Control at Automatic A/C Mode

Implementation of Wireless Automatic Control System for Vehicle Interior Environment

Study of Non-Drip Water and Humidity Measurement-Control Technology

A Research on the Optimization of the Location and Control Parameters of Temperature Sensors in Automotive A/C System