Abstract:This study aims at establishing a model for close-contact melting (CCM) of shear-thinning fluids. We presented a theoretical framework for predicting the variation of liquid melt film thickness and motion of unmelted solid for both Carreau and power-law fluids. We identified the appropriate energy equation considering the convective effect and derived an analytical temperature profile across the liquid film. Using the lubrication approximation, force equilibrium relationships and the corresponding numerical approaches were built. By using laser interferometry and photographic recording methods, we found excellent agreement between numerical solutions and experimental results for Carreau liquids, revealing that the convective effect weakens heat transfer and melting rate. We identified the critical liquid film thickness that determines three situations of CCM in the theoretical model for Carreau fluids. Numerical prediction demonstrated that the CCM of Carreau fluids can be almost equivalent to that of power-law fluids if the initial film thickness is greater than the critical value. Finally, approximate analytical models were developed for both Carreau and power-law models. For the applicability of the approximate analytical solutions, we derived two-and three-dimensional dimensionless phase diagrams of validity range and identified a key dimensionless group (?Re)Re-4/3 [3 ln(Ste + 1)](1/3) Pe(-1/3), where ? is dimensionless characteristic time, Re is Reynolds number, Ste is Stefan number and Pe is Peclect number. The reliability of the approximate solutions was verified by comparing with the numerical results. These approximate solutions enable convenient and low-cost computational prediction of the dynamic CCM process of shear-thinning fluids.

Velocity Field Analysis for Correcting Model of Exponential Viscosity under Thin Film Lubrication

Finite Volume Method of the Microfiltration of Viscoelastic Polymer Solution

Analysis on the oil film uniformity of hydro-viscous drive friction pairs

Close-contact Melting of Shear-Thinning Fluids

Analysis and Comparison of the Models for the Rarefied Gas Effect on Gas Lubrication

VISCOSITY MODIFICATION AND ITS APPLICATION IN COMPUTATION UNDER THIN FILM LUBRICATION STATE

Modeling and Analysis of Interfacial Electro-Kinetic Effects on Thin Film Lubrication

Generalized Maxwell Velocity Slip Boundary Model

A New Postulation of Viscosity and Its Application in Computation of Film Thickness in TFL1

A Lubrication Deviation From the Classical EHL Theory by the Lubricant Viscoplasticity: Part I - Film Thickness Dependence

Modelling for Water-Based Liquid Lubrication with Ultra-Low Friction Coefficient in Rough Surface Point Contact

Visco-elastohydrodynamic Lubrication and Wear Model Amended by Deformation Velocity

Lubrication performance analysis of sealing structures in rodless open cylinders

A Study of Dynamic Contact Angles of Shear-Thickening Power-Law Fluids

A Dynamic Rheological Model for Thin-Film Lubrication

Aspects of modeling and numerical simulation of dry point contacts between viscoelastic solids

A Computer Thermal Model of Mixed Lubrication in Point Contacts

Study on Lubricant Thermal Influence on Flow Factors

A New Lubrication Equation for Ultra-Thin Gas Film in Hard Disk Drives

Effect of cutting and feed speed on lubrication performance of large hydrostatic turntable with constant linear velocity

Theoretical and Experimental Study on Dynamic Wetting of Power Law Fluid Under Wilhelmy Plate Method