Abstract:In this paper, the effect of micro-dimple textures (produced by a laser) on the tribological properties of bearings is investigated. This study offers guidelines to reduce the friction torque of the bearing pair and addresses the problem of difficult start-ups after shutdowns. Micro-pits with different texture diameters and depths were machined on the surface of journal bearings. Then, the impact of several different texture parameters on the tribological performance of the bearing pairs was studied using an orthogonal experimental design. Subsequently, the surface morphology of the bearings before and after the friction and wear test was observed using scanning electron microscopy (SEM) and energy-dispersive spectrometry (EDS). These observations were then used to determine the type/state of friction and wear, which also improves our understanding of how texture affects the service life of bearings. The results indicate that the bearings’ micro-pit surface hardness follows an approximate parabolic spatial distribution that decreases along the micro-pit wall. Furthermore, the laser processing of surface textures was found to cause hardening in certain areas, and the chemical composition of elemental carbon and oxygen at the inner surface of processed bearings increased by 31.1% and 7.9%, respectively. Moreover, abrasive wear was identified as the primary form of wear. The textured surface’s antifriction mechanism primarily functioned to trap particles, which acted as a secondary lubrication source and altered the lubrication states by serving as a medium for supplied lubricants. The results confirm that a suitable selection of texture parameters can not only effectively reduce the friction coefficient without shortening the service life of the bearing pair but also facilitate the smooth start-up of the rotor–bearing system.

Point-grinding Texture Characteristics and Its Influence on Tribological Property of Parts

Study on Micro-Surface Texture and Tribology Characters of Ground Surface in Point Grinding Process

EFFECTS OF POINT GRINDING SURFACE TEXTURE ON CONTACT AND WEAR CHARACTERISTICS UNDER DRY SLIDING CONDITION

Characteristics of the Point Grinding Surface Texture and Its Effects on Evaluation Parameters of the Surface Roughness

Influence of Cross-Grooved Texture Shape on Tribological Performance under Mixed Lubrication

Influence of Surface Texture on Tribological Properties under Condition of Grease Lubrication

Quantitative Analysis and Evaluation of Valve Core Spherical Surface Grinding Texture

Relationship of Grinding Textures and Surface Friction Coefficient of Common Steels

Study on the Mutual Influence of Surface Roughness and Texture Features of Rough-Textured Surfaces on the Tribological Properties

Effects of commission condition on the tribological properties of surface texture:a review

Surface Texture and Its Influence on Tribological Properties

Experimental Study of the Effect of Surface Texturing on the Lubrication Performance in Point Contacts

Effect of surface texture on the frictional properties of grease lubricated spherical plain bearings under reciprocating swing conditions

Surface Texture Design and Its Tribological Application

Influence of Thermal-mechanical Coupling of Single Particle on Grinding Surface Roughness

Research in Improving Tribology Performance by Surface Texturing

Analyzing on Surface Texture Processed by Grinding

A comparative study of tribological performance of helical gear pair with various types of tooth surface finishing

Experimental Study on the Influence of Different Lubrication Mediums on Tribological Properties of Textured Surface

Influence of the Abrasive Shape-Position Characteristic on the Grinding Thermo-Mechanical Coupling

A Study on Micro-Pit Texture Parameter Optimization and Its Tribological Properties