Abstract:This paper presents an experimental and theoretical study of surface generation in the ultra-precision grinding of hard and brittle materials. The study takes into account the material properties, the relative vibration between the grinding wheel and the workpiece, the machining parameters and the phase shift of the grinding process. The Taguchi approach is employed to study the influence of machining parameters on the surface quality and shows that the feed speed and rotational speed of the workpiece are key factors. Experiments have been conducted to study individual variables, and the results further show that the feed rate and the cross-feed distance have a significant effect on surface generation. It is found that the spirals around the central area of the workpiece are the primary mechanism for surface generation, which originates from the synchronous relative tool-work vibration. The integral part of the ratio of the rotational speed of the grinding wheel to rotational speed of the workpiece determines the number of spirals and its fractional part controls the spiral geometry. A theoretical model for predicting the single spiral generation has been developed to explain the accumulation of the phase shift and the geometry. The changeable feed speed near the end of grinding is also modelled, revealing the approximate straight lines around one circle in the central region. The simulated results indicate that the theoretical models and the ground surfaces are in close agreement. The scallop-height model is developed to calculate the influence of phase shift on surface quality, and it is found that the phase shift near the medium value can effectively improve surface quality. Finally, a comparison of different surface generation mechanisms in grinding mould steel, tungsten carbide (WC) and reaction bonded silicon carbide (RB-SiC) is made. It is interesting to note that the Spanzipfel effect contributes to the surface generation not only on ductile materials such as mould steel but also on brittle materials such as WC and RB-SiC. The Spanzipfel effect is the most significant in grinding mould steel. For WC and RB-SiC, the ground surface contains both a ductile region and a brittle region in the form of micro-fractures.

Quantitative Analysis and Evaluation of Valve Core Spherical Surface Grinding Texture

Research on the Analytical Thermal Model in Surface Grinding by Cup Wheel

Numerical Simulation and Experimental Validation of Fixed Abrasive Grinding Pad Topography

Modeling and Simulation of Grinding Surface Topography Considering Wheel Vibration

Influence of Thermal-mechanical Coupling of Single Particle on Grinding Surface Roughness

The Analytical Model of Ball-Spinning Force for Processing an Annular Groove on the Inner Wall of a Steel Tube

A parametric evaluation model of abrasive interaction for predicting tooth rough surface in spiral bevel gear grinding

An experimental and theoretical analysis of surface generation in the ultra-precision grinding of hard and brittle materials

The Modelling and Analysis of Topographical Properties with the 'Through-the-process' Grinding Wheel Model

Surface roughness model of ultrasonic vibration-assisted grinding GCr15SiMn bearing steel and surface topography evaluation

The Modelling and Experimental Verification of the Grinding Wheel Topographical Properties Based on the 'Through-the-process' Method

Analysis of spherical chips after grinding

Characteristic quantitative evaluation and stochastic modeling of surface topography for zirconia alumina abrasive belt

Analysis, Modeling and Experimental Study of the Normal Contact Stiffness of Rough Surfaces in Grinding

Research on ultrasonic grinding ZrO2 ball valve with a cup-shaped diamond grinding wheel

Numerical modeling of material removal mechanism and surface topography for gear profile grinding

Design and Optimization of the Surface Texture at the Hydrostatic Bearing and the Spindle for High Precision Machining

Analytical modeling of abrasive grain-workpiece cutting coefficient and experimental investigation on tangential ultrasonic vibration-assisted forming grinding gear

Research on Internal Flow Field Characteristics of Straight-Groove Texture Using Three-Dimensional Modeling

A simulation method for surface height distribution of end-face grinding workpieces

Study on the effect of the strengthen grinding process surface coverage on the micro-morphology, micro-hardness, roughness, and residue stress of GCr15 bearing steels