Abstract:The rotor unbalance is a major source of rotor vibrations. Rotor vibrations often produce many undesired effects like noise, wear and fatigue, etc. In this paper, we try to seek the benchmark solutions for the unbalance responses of complex rotor-bearing system. The presented approach could be seen as the extension of transfer matrix method (TMM) in some sense. For the TMM, a disk or supporting structure cut off one uniform shaft element into two and someone must use the compatibility condition between these two new elements to derive the transitive matrix. However, for the presented approach, it directly solves the governing equations of uniform shaft elements with consideration of the effects of disks and supporting structures. Thus, this analytical approach is advantageous in reducing the times of matrix multiplication between state matrices and field matrices. One only needs to calculate the inversion of 16 × 16 dynamic stiffness matrix to find the steady state response. It saves the computer memory and is easy to be programmed. In addition, this analytical approach avoids the problems of selecting optimal discretization mesh densities in the case of FEM applications. For arbitrary linear boundary condition, the benchmark solutions are always easy to be obtained. The numerical simulation is carried out and two numerical examples are given to validate the new solutions. In which the finite element method is used as the numerical approach. Simulation results show that the benchmark solutions match very well with the FEM results. The effects of anisotropy in the supporting structures on the rotor's dynamic behavior, which are observed in this work, are also in accordance with many references. This validates the benchmark solutions further.

Design and Realization of the Dynamic Characteristics Analysis System for a Rotor-bearing System

The Design of Dynamic Balancing Machine Based on Finite Element Analysis

Studying on the Technique of Integration Analysis to Rigid-Flexible Mixture Virtual Prototyping in Complex Mechanic System

Design and Realization of Rolling Bearing Stiffness & Rotor System Dynamics Network Calculating System

Development of the Dynamic Analysis Software of Rolling Bearings Based on Mixed Programming Method

Integral analysis on dynamic characteristics of high-speed ball bearings and rotor system

Design and implementation of an auxiliary calculation system for structural parameters of the rotor system of a roller huller

Design and Implementation of Analysis System for Skid Damage of High Speed Rolling Bearing Based on VB and VC

Dynamics Analysis Control on Dual Delay Bearing-Rotor System

Analysis on Dynamic Characteristics of Aero-engine High-speed Ball Bearings

An on - Line calculation method of dynamics properties for the bearing - Rotor system

Dynamic Model and Numerical Simulation of Multi-stage gear-rotor-bearing System

Axiomatic Design Method for Supercritical Rotor Dynamics Integrating Nonlinear Deep Knowledge

Benchmark solutions for the dynamic analysis of general rotor-bearing system with arbitrary linear boundary conditions

Dynamic modeling and analysis for a drive axle gear transmission system

Dynamic Analysis on Rotor System Supported by Active Electromagnetic Bearings

Dynamic Analysis Of High-Speed Face Gear Rotor System Applying Lumped Parameters

A General Dynamic Model Coupled with EFEM and DBM of Rolling Bearing-Rotor System

Online identification of the bearing dynamic parameters for rotor-bearing systems

Software System Development of the Outer Rotor Permanent Magnet Generator Experimental Platform

Simulation and Experimental Analysis of Rolling Element Bearing Fault in Rotor-Bearing-casing System