Abstract:Splitting droplets is becoming a major functional component in increasing number of droplet microfluidic applications, and there is an increasing interest in splitting droplets into two daughter droplets with different volumes. However, designing an asymmetric droplet splitter and predicting how a droplet splits in such designs is not trivial. In this study, numerical simulations were conducted to study droplet breakup in asymmetric T-junctions of square cross-sections having different pressure gradient ratios (i.e. T-junctions with outlet branches of different lengths). The goal of the simulation is to identify the conditions where a parent droplet breaks or does not break into two smaller droplets of different sizes (so called critical condition) and to identify the important fluid and microchannel parameters in this process. Four modes of droplet breakup (primary-, transition-, bubble-, and non-breakups) are identified and an empirical correlation is introduced that can predict the breakup/non-breakup of the droplet based on the parent droplet size and the capillary number. The simulation results are then compared with experimental data to verify its accuracy and the effect of fluids properties on the proposed correlation are studied. Two major asymmetric breakup mechanisms are determined, namely "breakup with permanent obstruction" and "unstable breakup". The numerical results show that the splitting ratio for the asymmetric breakup mechanisms depends on flow conditions and dwell time of the droplet at the junction prior to splitting. Finally, the results from two-dimensional and three-dimensional simulations were compared. It is shown that two-dimensional simulation may not accurately predict the breakup behavior for asymmetric droplet breakup and viscosity ration has a greater effect on the prediction critical condition.

Breakup Characteristics of Bubble Moving in T-Junction Micro-Channel

Experimental Measurement of Bubble Breakup in a Jet Bubbling Reactor

The bubble breakup process and behavior in T-type microchannels

Bubble breakup in a swirl-venturi microbubble generator

3D Numerical Simulation of Droplet Passive Breakup in a Micro-Channel T-junction Using the Volume-Of-Fluid Method

The Instability of Monodisperse Bubbles Passing Through a Confined Geometry

Modelling of Mass Transfer for Gas-Liquid Two-Phase Flow in Bubble Column Reactor with a Bubble Breakage Model Considering Bubble-Induced Turbulence

Behind the Non-Uniform Breakup of Bubble Slug in Y-Shaped Microchannel: Dynamics and Mechanisms

Dynamics of Partially Obstructed Breakup of Bubbles in Microfluidic Y‐junctions

Bubble breakup in microchannels: A review

Dynamics of Bubble Formation in Highly Viscous Liquid in Co-Flowing Microfluidic Device

Experimental Study on Breakup of a Single Bubble in a Stirred Tank: Effect of Gas Density and Liquid Properties

Experimental visualization of bubble generation and breakup in T-junctions of microchannels

Three‐Dimensional Simulation of Bubble Formation Through a Microchannel T‐Junction

Breakup of a liquid jet in co-flowing air streams

A Comparative Study on the Breakup of Newtonian and Viscoelastic Liquid Films

Breakup dynamics of nanofluid droplets in T-typed microchannels

GENERATION AND BREAKUP OF MICRO AIR BUBBLE IN CO-FLOWING OF WATER IN MICROCHANNELS

Bubble Splitting under Gas–liquid–liquid Three‐phase Flow in a Double T‐junction Microchannel

Experimental Study on Droplet Breakup in an Orifice Jet Mixer

Prediction of Microdroplet Breakup Regime in Asymmetric T-Junction Microchannels