Abstract:Abstract The low corrosion resistance of Mg alloys is the major challenge that slows down the actual application of these lightweight materials. Magnesium has a more negative standard reduction potential than common alloying elements — aluminum and zinc. The formation of local galvanic couples was reported in AZ31-AZ91 alloys due to precipitation of secondary phases, and it was suggested that these galvanic couples provided initiation sites for localized pitting corrosion. Scanning Kelvin probe force microscopy (SKPFM) technique is a precise tool to study the Volta potential distribution on surfaces. Since the lateral resolution of SKPFM maps can reach several nanometers, the technique can be used to detect the deformation-induced formation of nano-particles and phases nucleates. However, the precision of the measurements is affected by several factors: tip-sample distance, humidity, the roughness of the surface and tip characteristics, i.e. tip radius, conductivity, and stiffness. Taking into account that magnesium surface is commonly covered by the self-forming oxide layer, which is reducing electrical sensitivity of the tip, the sample preparation and handling can be considered the major factor that affects the quality of measurements by SKPFM. The aim of our work was to investigate different alternative sample preparation methods for SKPFM and to compare the results (Volta potential maps and topography) with the optical, Scanning Electron Microscopy and Energy Dispersive Spectroscopy maps. The samples were prepared by mechanical polishing, mechanical polishing followed by chemical etching and mechanical polishing followed by ion-milling. For our study, we used a laboratory hot-rolled magnesium-aluminum alloy samples and analysis were focused on typical metallurgical features: surface topography, intermetallic nano-particules and phases nucleates, grain boundary precipitates and grain boundaries.

Ultra-thin sections preparation of magnesium and its alloys

Specimen Preparation of Aluminum Alloy Powders for Transmission Electron Microscopy

Sample preparation and research of amorphous composite material for transmission electron microscope

Simple preparation method for TEM cross-sectional specimens of thin-film materials

Sample Preparation Methodologies for In Situ Liquid and Gaseous Cell Analytical Transmission Electron Microscopy of Electropolished Specimens

Transmission Electron Microscopy Study of Aqueous Film Formation and Evolution on Magnesium Alloys

A new method for batch staining of ultra-thin sections

Effect of Specimen Preparation Method on Transmission Electron Microscope Investigation in a Bulk Metallic Glass

Effect of Sample Preparation on Volta Potential Measurements of Plastically Deformed Mg-Al Alloys

Advanced preparation of plan-view specimens on a MEMS chip for in situ TEM heating experiments

Ultrafine-grained Mg alloy: Preparation, properties, design strategy

Preparation of TEM Samples of Ferritic Alloys.

Fast Preparation of Ultrathin FIB Lamellas for MEMs-Based <i>In Situ</i> TEM Experiments

B22-O-02 Characterization of Precipitates in Magnesium Alloys Using Atomic Resolution HAADF-STEM and EDS

Formation of Ultrafine Grains in Magnesium Alloy During Dynamic Extrusion at Room Temperature

A novel ultra-low current and temperature controlled electrochemical method for exposing various kinds of secondary phase precipitates: Application to the sample preparation of zirconium alloys and some other common alloys

Study on Metallographic Techniques for Cast Mg Alloy

Preparation of TEM Specimens from Gas-Atomized Fe-6.5wt.%Si Powders with Several Micrometers Using Focused Ion Beam

Application of Microstructural Analysis to the Microstructure Observation of the Semi-solid Alloy

Microstructures and Mechanical Properties of an Ultrathin Wall High-Pressure Die Casting Mg-8Zn-8Al (wt%) Alloy

Peelable Fe-based alloy film specimen for HRTEM observation