Abstract:In this study, a comprehensive examination was conducted to explore the technology involved in the recovery of waste heat from flue gas emitted by a 1000 MW unit. Traditional methods are constrained in their ability to harness waste heat from flue gas solely for the purpose of generating medium-temperature water. The system being examined not only recovers waste heat but also utilizes it to generate steam, thereby greatly improving resource efficiency. The process entails utilizing the flue gas to heat water to a certain temperature, followed by subjecting it to flash evaporation. This process leads to the generation of low-pressure waste heat steam. Within the steam ejector, the waste heat steam combines with high-pressure motive steam extracted from the source, resulting in the formation of medium-pressure steam. Within the steam ejector, the waste heat steam blends with high-pressure motive steam drawn from the source, forming medium-pressure steam that eventually feeds into the A8 steam extraction pipe (low-pressure turbine pumping pipe). The present study examines the fluctuation patterns in motive steam flow, suction coefficient, waste heat steam volume, and outlet temperature of the flue water heat exchanger when different motive steam sources are used. Additionally, the research calculates the reduction in CO2 emissions, the coal consumption for power supply, and the cost savings in fuel for the retrofitted system. The findings indicate that maximizing energy utilization can be achieved by operating the retrofitted unit at the lowest feasible waste heat steam pressure. The implementation of the new system has resulted in a substantial decrease in coal consumption for power supply. When employing main steam as the extraction steam source, the consumption of coal for power generation decreases in proportion to the decrease in waste heat steam pressure while maintaining a constant unit load. When the waste heat steam pressure reaches 0.0312 MPa, the recorded coal consumption for power generation varies between 289.43 g/kWh at 100% turbine heat acceptance (THA) and 326.94 g/kWh at 30%THA. When comparing this performance with the initial thermal power plant (TPP) unit, it demonstrates reductions of 2.26 g/kWh and 1.52 g/kWh, respectively. After implementing modifications to this 1000 MW unit, it is projected that the annual CO2 emissions can be effectively reduced by 6333.97 tons, resulting in significant cost savings of approximately USD 0.23 million in fuel expenses. This system exhibits considerable potential in terms of emission reduction and provides valuable insights for thermal power plants aiming to decrease unit energy consumption.

Energy-saving analysis for heat recovery from low-temperature flue gas in coal-fired units

A Novel Flue Gas Heat Recovery System Integrated With Air Preheating in a Utility Boiler

Recovering Low-Grade Heat from Flue Gas in a Coal-Fired Thermal Power Unit

Analysis of an Exhaust Heat Recovery Process of Integrating Bypass Flue and Condensate Air Heater for Efficient Power Generation

Study on Heat Recovery System of Coal-Fired Power Plant Integrated With SCO2 Power Cycle

Performance Analysis and Optimization of Flue Gas Waste Heat Recovery System of a 600MW Coal-Fired Power Plant

Techno-economic analysis on a new conceptual design of waste heat recovery for boiler exhaust flue gas of coal-fired power plants

A novel boiler cold-end optimisation system based on bypass flue in coal-fired power plants: Heat recovery from wet flue gas

Techno-Economic Comparison of Three Processes for Boiler Waste Heat Recovery

Performance study and application of new coal-fired boiler flue gas heat recovery system

Thermal economic analysis on low-temperature waste heat recovery

An Ejector and Flashbox-Integrated Approach to Flue Gas Waste Heat Recovery: A Novel Systematic Study

THERMO-ECONOMIC ANALYSIS ON WASTE HEAT AND WATER RECOVERY SYSTEMS OF BOILER EXHAUST IN COAL-FIRED POWER PLANTS

Thermo-economic analyses on a new conceptual system of waste heat recovery integrated with an S-CO2 cycle for coal-fired power plants

Performance analysis of an efficient waste heat utilization system in an ultra-supercritical coal-fired power plant

Waste heat recovery system using coal-fired boiler flue gas to heat heating network return water

Waste heat recovery from coal-fired boiler flue gas: Performance optimization of a new open absorption heat pump

Development of integrated technology for waste heat recovery from humid flue gas of hot water boiler

Thermo-Economic Optimization on the Waste Heat Recovery System of SCO2 Coal-Fired Power Plants

The Recovery of Waste Heat of Flue Gas from Gas Boilers

Computational boundary improvement and performance optimization of the flue gas waste heat cascade utilization system of the ultra-supercritical 1000 MW generator set