Abstract:Gas turbines (GTs) can play a significant role in the new power system with high renewable energy penetration. This paper develops the supercritical CO2 power cycle (CPC) to improve its efficiency through waste heat recovery (WHR), and the integrated system is designed for large ship propulsion. An ideal WHR cycle perspective is drawn to guide the evolution of the CPC configuration, and the techno-economic models of these CPCs are established. Then, a system and component two-level evaluation framework with corresponding criteria is formed: through thermodynamic and multi-objective optimization and comparison, the layout with optimal comprehensive performance was identified; the conventional and advanced exergy analyses, as well as their comparison, were carried out to obtain its components’ information. Results show that both the recuperative and the split-flow can substantially enhance the CPC’s WHR capability, while the over-expansion has minimal effect. By integrating the CPC, the GT’s efficiency can be improved by approximately 33%. Multi-objective optimization reveals that the partial heating layout outperforms the recuperated layout in terms of overall performance. Specifically, despite having a similar levelized cost of electricity of 4.73 cents/kWh, its total heat recovery efficiency (THRE, 17.6%) exceeds that of the latter by a margin of 14.2%. The heater has the most considerable exergy destruction in the optimal layout, accounting for 19.3%. With the current technology, the THRE can be increased to 25.5% through component refinement. Conversely, the advanced exergy analysis indicates that the heater has a minimum improvement potential of 1.52%. The turbine has the highest endogenous avoidable exergy destruction ratio of 31.8%, which deserves focused development and investment.

Review on Key Technology of Operation and Maintenance for Gas-Steam Combined Cycle Power Generating Units

Advanced Maintenance Strategy for Power Plants - Introducing Intelligent Maintenance System

Optimization of Start-up Process in Combined Cycle Steam Turbine of a Power Plant

Research on Optimization of Residual Natural Gas Distribution for Combined Cycle Unit Shutdown Process

Optimization on Start-up Process of Steam Turbine in Combined Cycle Generating Units

Study on Quick Start-up of Steam Turbine in a Gas-Steam Combined Cycle

Preventative Maintenance Decision System For Gas Turbine Based On Operation Status Information

Prognostics of Gas Turbine: A Condition-Based Maintenance Approach Based on Multi-Environmental Time Similarity

Discussion on the design of 350 MW-class gas-steam combined cycle units

Control Technology of Supercritical Power Gene ration Units and its Development Trend

Hot Gas Path Evaluation and Life Management for Heavy-duty Gas Turbines

Modeling and Control of Supercritical and Ultra-Supercritical Power Plants: A Review

Experimental Study on Large Turbine HP-Valve’s Excitation Fault Caused by Steam’s Unsteady Flow and Its Economic Solution

Condition monitoring and fault diagnosis system for combined large scale turbines and generator sets

A Review of Control Technologies of Combustion Optimization in Utility Boilers

Maintenance for Heat Recovery Steam Generator of 800 MW-class Gas-steam Combined Cycle Unit

Performance Enhancement of Gas Turbine by Supercritical CO2 Cycle Construction: System and Component Two-Level Evaluation

A Review of Optimal Operation of Integrated Energy System Including PtG System

Discussion on Development of Gas-fired Heating, Power and Cooling Cogeneration System in China

ICOPE-15-C114 Development and Key Problems of Ultra-Supercritical Double Reheat Plant in China

On-line Monitoring and Failure Warning of High Pressure Regulating Valves' Operating State for Large Power Steam Turbine